Forum Replies Created
-
Posts
-
Re: Between the drums
Thanks for the help Clive,
Whilst moving the inner drum to try and look, I seemed to have dislodged the metal strip and the drum spins freely by hand!!
My problem now is, do I think great that’s sorted! (hoping the strip will just lie at the bottom of outer drum for ever and ever) 🙄 or do I (knowing that he is going to pounce up when I least suspect it) try and get it out 8O.
I shall open a can of Spitfire, just one, to help me decide and to boost my perseverence.
All the best everybody.
Andy.Re: Common Sense
My birthdays a little way off (5th November) however I have received a very nice present, just the other day! Wrapped in paper with “phase 1” all over it…….. :rotfl:
Kevin
Re: margherita 2000 troubleshooting
i have a problem
my machiene dont spin any more
every program its spinsbut for dry spin it do’s nothing
i check the filter below but i can’t open iti can turn it to the right but to open it its stuck
Re: Removing Cover on Samsung SR-S22…
Hi Dave,
Thanks for the quick reply!
The original engineer apparently replaced a pcb board but to my mind I would imagine that the problem is, as you say, with the auto-defrosting.
I was loathe to get an engineer out again if the problem was just going to repeat itself but if a permanent repair can be effected that is a different matter. Do you think it is fixable permanently?
I’ll report back shortly.
Re: Homark 700401 oven not heating up
tonyclifton wrote:it be main oven element,which is located behind a panel at the back of the oven from the inside normally held in place by 4 screws,look for burnt marks on element ,then carefully remove not to lose wires down back and check with meter.
check out shop@ for one… over on left.
remember to turn POWER OFF 1stI can get to the back of the cooker easy enough if that would make life easier. Have you any idea which element it is. What do i expect across meter.
Re: Removing Cover on Samsung SR-S22…
I also have a Samsung F/F (SR2028FSM) that has stopped working on the fridge side. I am going to try the defrost trick to see if that helps. Thanks for the tip!
Samsung – who have the worst customer service ever – fixed the machine once but it stopped working about two months afterwards.
There is obviously some design flaw if this keeps happening. Does anyone know of a way of permanently avoiding the ice build-up without having to manually defrost every couple of months? Thanks.
Re: LG WM1290FHB
an update! YOU GUYS CURED MY WASHING MACHINE!
it has been working perfectly. Thanks! what a great forum. :tup:Re: AMDEA
if you plan to arrive around 0930 we will all be ushered into the same car park, which seems a good starting point. There is usually a booth where you can “pay” for your parking, try looking out for the ugly scots one around 0945, he’ll be with two shady looking geezers 8)
Kevin
Re: AMDEA
If I remember the hall right there should only be one bar.. :beer:
I think that should be a suitable place to meet up :tup:
bryan
Re: dishwasher di67 flashing lights
thankyou will try that. have looked in the bottom and lifted out section and it appears to be full of water
will let you know thanks againRe: What washer for up to £300?
Hi,
Thanks for that – will try and get a look at some today.
What do you mean turn the light up? ADJUST YOUR MONITOR! 😉
…will have a word with my website designer 🙂 Thanks for looking, hope you liked the pictures (if you could see them).
Cheers
