[allan73]

Re: hotoint ctd40 very noisey

Good tip Helo_75 😉

[allan73]

Re: Bendix BIW105w (914211107)

Might be worth spending some time checking for yourself if it heats, I use an energy monitor for this 😉 .
Had many reports of m/c’s not heating only to find out customer is incorrect.

[allan73]

Re: Zanussi WJD1257W Dryer not working

Ditto, had a few of these with broken wires to lower ntc.

[allan73]

Re: Hoover Vision HD – VDH8162-80 – Noisy spin

As Martin points out this m/c will be covered by Hoover’s parts warranty if less than 5 yrs old, but I did’nt realise the labour charge was reduced if under 2yrs 😯 .

[allan73]

Re: Tecnick DW2677/1 (whirlpool) wireing loom damaged.

Thanks Dave.

[allan73]

Re: Indesit DI450 fault codes.

Thanks again Martin 🙂

[allan73]

Re: Hotpoint DF62

Thanks for the advice, just hope it is’nt a tricky leak :rolls:

[allan73]

Re: BOSCH WFF0220

Or maybe heater going to earth when it’s hot.

[allan73]

Re: Beko D531 Thermal Cutout problem

It’s the button ones Ive had problems with, have they been changed ?

[allan73]

Re: Pulley Bolt

Try warming it up with a blow lamp to melt the loctite.

[allan73]

Re: Beko D531 Thermal Cutout problem

Had quite a few of those TOC’s go down, think they must be c**p !

[allan73]

Re: Candy CM1146S

Gotta be board I would think.

[allan73]

Re: Hotpoint wt741

Was’nt one of the cleanest houses Mike, if I scout around I might have a display board off a scrapper I’ll take it with me if I have.

[allan73]

Re: Hotpoint wt741

From what I can remember Martin I tried and cancelled several programmes with no problems 😕

[allan73]

Re: Hotpoint wt741

Just got a call back to this today same fault, any Idea’s Guys ?

[Author]

Posts