[AMS]

Re: creda cooker

I think you’ll find it’s the same as used in quite a few Bellings. It’s a 21″ 13w slim tube. Probably get one from an electrical retailer. The starter is a standard flourescent tube starter for that wattage. On Connect, the tube is code 5031680830392 (£5.52+) for the Belling one and 5031681416717 (£8.90+) for the Creda one.

Hope this helps,

Dave

[AMS]

Re: Dyson dc07 animal wont pick up

Split “internal hose” down at the bottom ❓

[AMS]

Re: Bosch WFF2000 Removing brushes

Hi Greg,
as far I was aware, the heater is accessable from the back on the WFF2000. Sure you’re not getting it mixed up with the WFB2000?

Dave

[AMS]

Re: Neff 6544WM

Can’t help you with the part no I’m afraid, but I do know that the spider is not available seperately, you will have to get the complete drum. I did one recently, just happened to have a spare one in my garage. See, keep something for 5 years and it will eventually come in usefull! The machine was produced by Siltal BTW.

Dave

[AMS]

Re: Admiral tumble drier AYE2200

Thanks for the info Mark. I found the old thread via a search and I was hoping it would be you that replied! I’ll give Maytag a call and see if they can help out.

Thanks again,

Dave

[AMS]

Re: Admiral tumble drier AYE2200

I’m needing a fan for one of these tumble dryers (split). Does anyone know where I can get one?

Cheers,

Dave

[AMS]

Re: whirlpool akz 151/wh

Is this the 481921078097? If so, then Masterpart are showing “low stock”, which of course could mean no stock. Worth a try though.

Dave

[AMS]

Re: Hotpoint WMA belt

OK then, I’ll stick a new belt on and see how it goes.
Thanks for all the replies guys,

Dave

[AMS]

Re: Hotpoint WMA belt

It’s a genuine belt, Jim. I’ve not replaced the belt, just refitted it each time. I was going to replace the belt when I returned tomorrow, but I’m clutching at straws a bit as I can’t see anything wrong with the original belt.

Dave

[AMS]

Re: Zanussi FJR1254W Error Code E90

E90 is the user code. You’ll need to go into the diagnostics mode to see what the specific code is. It could be anything from E91 to E94. In my experience, these codes usually end up with a pcb change.
🙁
Dave

[AMS]

Re: White Knight CL847 sensordryer

Thanks for all the replies guys. Yes it was the carbon brush that had fallen out. However, I managed to retrieve the little sod by turning the machine upside down. 😀

Cheers all,

Dave

[AMS]

Re: Zanussi FLE1216W main pcb replacement.

Thanks for the reply, Flyman. I’ll get a new board and give it a whirl. If I get any problems, I’ll be back 8) .

Dave

[AMS]

Re: IGNIS D/W

It’s a Whirlpool Jim, so parts should be readilly available from the usual sources. There are several variants of the ADL347 so service no essential.

Dave

[AMS]

Re: Random Thoughts No.54

Hear hear to that.

Dave

[AMS]

Re: Ariston/Hotpoint module wiring

Thanks for the replies Guys. I think you’ve hit it there Johnny. What a ridiculous colour for an earth!

Dave

[Author]

Posts