Forum Replies Created
-
Posts
-
Re: Hoover twin tub spin bearing.
Thanks for that – when I searched for T5090 it didn’t come up. Cheers!
Steve.
Re: DASA membership at all time low?
Connect sent me an invitation to a DASA annual trade show on October 1st. Connect sending out the invites? Hmmm……. 😳
Steve.
Re: bush dishwasher pcb
hilly wrote:I am trying to acquire a part number & supplier for a bush wqp12-9348 sn 131124585 d/w pcb
many thanks
Put “wqp12 module” in as a search on Connect – stock item @ £45 + VAT. MDI674001020464 is the part number. Qualtex show it at £30 + VAT…. just knock off the MDI at the beginning. 😉
Hope that helps!!
Steve.
Re: 1607 inner drum removal.
Thanks Ken – 4lb lump hammer eventually did it. The seal was stuck fast to the drum shaft and needed overnight soaking with penetrating oil to finally shift it Friday morning. All done and back with customer!!
Cheers,
Steve.
Re: Beko DSFN1530B dishwasher dead.
Display PCB had failed as well – hope that helps others in the future.
Steve.
Re: culina oven
Beko related machine from B&Q. To see them, Google search “Culina” and select images. Loads of photos and all look very Beko……. and Chinese.
HTH,
Steve.
Re: bush dishwasher wv12-75db heater
Part number 5045382229927 in stock at Connect. £46.43 to me + VAT. To get the full list just search “WV12” only – there’s quite a large amount of parts available for it.
HTH,
Steve.
Re: Aqualtis AQ113L297I
Before you smash it do the pressure switch reset procedure that Jim posted higher up in this forum. It may not work, but it has many times for me. Change the pump for new as well. The selector can often be sorted by removing the board and flooding the selector switch with switch cleaner and turning it back and forth. Liquids like coffee and soap get spilt over the control panel and flow around the program knob and can adversely affect its function.
Anyway, “Aqualtis” is cockney rhyming slang for “pile of cr@p”……Steve.
Re: How to run test cycle on Whirlpool ADP6332
Run it on a normal cycle – if you have diagnosed the fault correctly and safety tested it then there should be no issues. The test cycle is really for quick diagnosis only.
Re: Beko dcu8230 water tank full
You need to clean out the float chamber that signals the “Tank full” light. That should be joined to the area the condensate pump is fitted to. Seem to recall it is accessed from the rear panel. (loads of screws!!)
HTH,
Steve.
Re: Hoover DYN9164DPG/L1-80 loom
Presuming you know which wire goes where, can’t you individually cut and re-tag each wire with insulated tags? The motor plugs are 6.3mm ordinary male amp tags so should be possible.
HTH,
Steve.
Re: Bosch WVT74104W/10 drier.
Full of fluff and o/c 80 degree stat under heater cover. Hope that helps others!!
Steve.
Re: Beko wm does nothing but drain stuck in program.
Brush motor on this machine (green holders).
HTH,
Steve.
