Forum Replies Created
-
Posts
-
Re: Whirlpool top loader lid switch.
http://www.whirlpool-larservice.com/lib/upload … 9400RL.pdf
Part # 8318084
Re: F&P error wont pump suspect controller
Still double check pump
Pumps can overheat and go out on overload
When pump cools Down it will then run
Just chaek that pumps not geeting to hotRe: Smart Drive 058 – Will not engage (#00101011=43)
Have to take out motor controller (Main PCB)
Straight Foward From thereRe: Smart Drive 058 – Will not engage (#00101011=43)
YEP Fault Code 43
Possibly OUT of Balance Micro switch
Power OFF
Control Panel Has Screws at Rear
Panel Tilts Forward
Switch Sits Under Main PCB On RHSRe: LG Advice
HELO WROTE then you could possibly run a replacement wire on the inside of the cabinet to the pcb, which may not be massiveley noticeable
i dont know anyone who would be prepared to hack the wiring out and refoam, leads to all sorts of problemsExactly a big Messy Job Doing That Way
My point is running The Wires EXTERNALLY [/list][/code]Re: Fisher and Paykel GW609 squeaks
Can be caused by dry Suspension arms ( IE Arms At Each Corner of Bowl) Lubricating spirings may resolve issue
Re: F&P SmartDrive 503
Filters At Tap End of Hose
Just a washer with filter to Stop Any grit etc getting into water valve
Valve has a Filter as well
Filters important to have if on tank waterRe: F&P SmartDrive 503
Water valve fault was what I was leaning to
Cold & hot valves are Different
Cold is Part # 426143 Its A proportional valve About $45 AUD
Hot is 426122 $30.00 AUDSlow filling is quite a common fault relating back to water valve fault
Also Check inlet hose filters are not blockedRe: LG Advice
All is Not Lost
We have had same faults down Here
Indeed has been wiring in cabjnet
You can check circuit from PCB on top of Fridge to Fan motor near compressor to confirm
If no circuit then normally wiring Fault
We have successfully overcome this problem by simply running a wiring loom down the outside rear of refridge
Doesnt look pretty but its at the back anywayRe: F&P SmartDrive 503
Unless i can get lights When Hold & Slow are lit can Give A fault code
Is the machine letting in water?
If So How fast is the Water coming in
Is both hot & cold coming in ?
What stage of the cycle is the machine faulting ?
Does it operate on spin only cycle ?
Need a bit more InfoRe: F&P SmartDrive 503
Lets Start from the top
Turn off Power (even Pull Plug)
Plug Back In & Run Diagnostics
IE PRESS & HOLD WashTemp Down & Power On
Press Advance Button ONCE
Press Spin Speed UP Button until HOLD & SLOW are LIT
This should Get the last Fault Code
Post Which Lights are Lit ETCRe: LG WM1480FHD
LE -lock ERROR
Usually Hall Sensor /Broken WiringUE – Imbalance Error
Sensor Down here is Part # 6501KW2001A (About $15.00AUD)
Re: Long Memories
I read with interest the newsletter concerning AIG
We have done work for them down here for quite a number of years
and can say up until now have been prompt with warranty payment work
Unlike the newsletter suggests .
The extended warranty companies keep us in work(They pay our rates Lab & RRP Parts)) and it would be a shame if they go down
