Forum Replies Created
-
Posts
-
Re: Fisher&Paykel Smartdrive 058 controller board help?
Rotor Postion Sensor (RPS)Error
Numerous threads on this forum related
RPS suffers from corrodded terminals ETC
Would also check for signs of leaking water from the main shaft
Problem can also be related to faulty motor controllerRe: Help or advice on Miele w2104 washing machine code
Rinse Light error is A Drive Fault
Simplest thing to check is the Drum Movement
Turn drum to see if it is not restricted in any way (IE Something caught between bowls)
Try this with drum belt on And then off to check free movement of motor
Other than that can be a Motor fault
IE worn motor brushes faulty Tacho or motorRe: LG GR559 JPA Fridge-Freezer
Drain is In the Freezer section behind the back fan covers
Could be possible blocked drain or the Ice bulid up around evaporator which has blocked drain
Power OffRe: F&P MW059NZ code 01000001?
Pressure sensor fault
Pressure Sensor Is part of The Main Motor Controller
Fault Code Suggestts you need a Motor Controller
If this part was replaced by repairer it would be under some sort of warranty
Original Part from FP has A 12 Month Warranty
i suggest you contact repairer.
Alas yes a shorted out lid switch can take out other componentsRe: Fisher DD603H
Suggest you check the link arms are not snapped
Also have had this problem were the heater plate is stuffedRe: Miele T5213
Wiring diagram usually tucked down the Bottom inside the Front panel
It Will be there somewhereRe: new panasonic microwave (puzzling part)
Think your referring to the waveguide cover
You need it
Leave it aloneRe: Fiher and Paykel MW511 fault code
Bowl check error
Similar to fault code 40
Ist Check that ther are no foriegn objects preventing clutch from reengaging (Ie remove agitator & check underneath)
2nd Check pressure tube is not kinked & has come off
Or it could also be a faulty RotorPostion Sensor(RPS)
or motor controller fault
Lots of Things with this Fault code to ponderRe: Fisher and Paykel IW709 code 62 & 105
First Thing to check would be pump
Pump could be over heating or it May be BlockedRe: smartdrive 509 error code 40 (00101000)
Bowl disengage fault
While carrying out bowl check Controller has indicated the bowl has not engaged even though pressure switch has indicated bowl is empty
Suggested actions
1 Too many suds/ie to much detergent
2 Check to see if bowl Is Lifting up & down Ok
3 Check that clutch is not & spline are not obstructed
To do this you will have to remove agitator from spline & plate under agitator
4/Check pressure tube has not kinked or come off
5 Could be a matter of a faulty motor controller(PCB)Yes there are alot of possible causes for this fault code
Re: Fisher & Paykel GW501 washing machine stops mid-cycl
Hot & Cold Lights Flashing is aUser warning that there is No water
IE Could be Slow flow rate /Blocked filters /taps turned off
When you say stops mid cycle at what stage is this ?Re: Ariston Margherita 2000 AL109X problem
F5 Error is As Iadom suggests
5 Flashes as per UK models
Check your PumpRe: Kleenmaid diswasher fault codes.
Its A Fault Code
d07 Leak detection. BAse Flooded & acitvates flood Switch
You have clear base of water to deactivate flood switch
Then have to figure why it leaked in the first place
For those in the know this is a Brandt dishwasher
