Forum Replies Created
-
Posts
-
Re: zanussi zdt6244 resistor
hi guys, thanks for your replys but resistor is the only visable damage th
at i can see. i was just going to try one before ordering a circuit board.tom.
Re: zanussi zdt6244 resistor
Hi the module no. is ako 546484-06 and the resistor that is blown is r60.Any help greatly appreciated.
Tom.
Re: Indesit Is70c condenser tripping
thanks guys, have checked pump and seems to be working fine, also have cleaned channel from pump to condenser no blockages, might try a new pump and see how it goes, thanks again for your replys . tom
Re: Hotpoint Condenser Tumble Dryer tripping
Hi Bernie how did you get on with this?I have the same prob with an Indesit dryer.
Tom.
Re: Whirlpool adp6830 owi removal
Cheers Steve I cleaned out the filter and sump and it seems to have done the job thanks for the help.
Tom.
Re: Whirlpool adp6830 owi removal
Cheers Steve yes that is what I am talking about its my first time coming across this type how does it work? The older ones were basically a pressure switch.Got it out yesterday exactly the way you said. The error code coming up is f04 there is a lot of muck in the filter and the sump would this be causing this.
Tom.
Re: Hotpoint wt540
Thanks for the reply Nelson but it was the display pcb I had one in the van luckily enough.
Tom.
Re: Electrolux EOC6630X oven error codes
Called to this m/c and the customer was right it was 3 flashes and I see from the manual sent from dave that the m/cs with a display give error codes f01 ,f02 etc and the f codes match up with the flashing light codes also on the manual so would I be right in thinking that f03 would be the same as 3 flashes of the light . f03 =eeprom configuation alarm.I have checked everything on the m/c so I do think its the board but am open to suggestions as a new board is expensive.
Tom
Re: Electrolux EOC6630X oven error codes
Cheers Dave its tght@eircom.net
Tom
