Forum Replies Created
-
Posts
-
Re: Hoover AQUALTIS AQXXF149UK
its made by hotpoint not hoover.
H20 water inlet problem (tap turned off)
F01 is a motor triac fault.Bob.
Re: New Hotpoint machines control module failing
has the appliance had a blockage and the customer has checked the filter, if so the pressure switch will need to be reset, also check the motor connector for broken wires, give them a tug at the connector, failing that it is the module.
Bob.
Re: LG FridgeFreezer not cooling plus bad smell
that was a common problem with the american style fridge freezer, the evaporator was leaking at the welded joints, i would contact LG first and see if the will cover the repair, model number and date of purchace would help.
Bob.
Re: LG WM1437RFD (Snr 611KWP00130)
Hi Rocker,
PM me an email address and i will forward you some info.
Bob.
EMAIL SENT
Re: Candy CMD146-80 washer Dryer
at 25c it should read 48.5k. have you changed the manual resets to the 185c type as the old ones were 175c.
Bob.
Re: Indesit WIA 121UK module
you may be lucky and the eeprom might be available, if not you use a blank one and programme it with the smartcard reader/writer with the low end adaptor attached.
Bob.
Re: TDS……ARGH!!!!!
i have the issue 1 2009 version and it runs fine on windows 7, just make sure that all the service packs are updated and install it and the pdf files in a seperate directory on the hard drive, dont use the default directory. then if you still have problems (i dont), run the programme in one of the older compatability modes.
