Forum Replies Created
-
Posts
-
Re: integrated cda washing machine f08
If its a fagor as most were its a motor circuit issue. Broken wire at the plug? Does it spin/wash?
Re: Siemens washer dryer WDI1440GB – steam coming from dispe
Steam would normally mean a condenser issue. Valve or blockage in the flow restrictor?
Re: Hotpoint WMF760 stuck on 1 minute?
Change the pump as these machines look for the correct resistance reading. I’ve seen it a few times on machines in a friends workshop
Re: Samsung oven BF641FST
http://knowhow.com/article.dhtml?articl … country=uk It would seem from this that its been put into “sale” mode. Explained in this article
Re: indesit di450 fault
PCb… Dispenser requires power to click. Power is only supplied for seconds to release the flap. Or should be anyway.
Re: Samsung oven BF641FST
I this sl is a lock. Holding in the centre knob for 20 odd seconds removes it. Aswell as being a rotary switch its a push button. Bryan
Re: Zanussi Dishwasher ZSF2450 Table Top
You can most probably hear the drain pump rather that the wash pump. This would be a flooding issue. Dishwashers have an anti flood system and should a leak occur the drain pump is activated immediately. Leave for a few days to dry and try again. Foaming due to bad powder or contamination can cause this ie fairy liquid :s
Re: Too strong water pressure
I’d say its because the waste outlet is too low causing syphon. As stated above. Machine will never reach “full”.
Re: SR-S2229CVW ice around fan in freezer
Probably left the door open. Evap would have cleared completely over one or two defrost cycles. Anything far from heaters would remain frozen. Bryan
Re: Beko WM6143B part numbers needed
Spin knob and selector knob also have an insert shaft behind. May want this also if your knobs are missing altogether.
