Forum Replies Created
-
Posts
-
If it gets warm but you get no water I’m afraid its got no gas. Dead in the water. Claim under the parts warranty.
Removing the ice-maker will cause the appliance to throw an error. If not straight away it will at power up or in case of power cut.
Re: Miele KFN12924SD warm fridge
Depending on the age of the appliance the fault may actually be with the the freezer. If the freezer is unable to reach the required temp the fridge will be shut down and all efforts thrown into the freezer. You will need either a Liebherr or a Miele engineer as the appliance is manufactured by Liebherr.
Re: Samsung RSH1DBRS fault
Also the fault would only display in event of engineer intervention or a power cut. Nothing to do with power outage.
Re: Samsung RSH1DBRS fault
Da32-00006u used to be part number. Press and hold top left and middle right buttons to bypass and get up and running. The sensor does need replacing though.
Re: Fault finding Russell Hobbs rh1247
Once machine is full it will be expecting motor action. If this does not happen it will shut down and drain. Some of these have very tight wiring at the front and the motors become unplugged.
Sent from marsRe: Haus dishwasher won’t fill
Humming is most likely drain pump rather than fill. Every cycle will drain for a min or 2 before filling begins. Does it have any water in the bottom? Did you remove the blank off from your sink waste?
Sent from marsRe: Hotpoint WDD960 drying temperature
Filter at rear of heater unit tends to block on these. Results in low flow past the heater. Usually throws an error due to over heating.
Sent from marsRe: Saumsung fridge freezer puzzle
Need to be checking that the heaters actually come on to defrost the evaporators. If the unit does not defrost itself as it should it will not switch back on. Unplug and restart it will be ok for one cycle then shut off again. PCbs do not fail often. Sensors and thermal fuses are common. Heaters also known to fail. Have never seen a compressor fail on one of these.
Sent from marsRe: Servis fridge freezer thermostat identification
Assuming your capillary goes into the fridge this item will be compatible. Or fit a vt9 or k59. But you will need to know your machines wiring for this
Sent from marsRe: trouble understanding the advanced search
That symbol on iPhone is accessed by hitting the .?123 button then #+= button you’ll then see it. Not sure about other handsets
Sent from marsRe: Zanussi FJDR bearing change – removing pulley
You have stripped the machine why not just replace the bearings. If they fail quickly you can consider replacing the shaft and bearings next time or scrap it. Only gonna cost a tenner and some time. Make sure to glue the seal into the tub and grease the sealing lip. Also replace the tub seal between two half a or silicon works well to ensure a good seal
Sent from marsRe: indesit slimline dishwasher
Could be the PCb is supplying more than the 12 volts required to operate the relay. Or these relays aren’t man enough for the job they do…..
Sent from marsRe: Hoover Condensor Dryer Leaking
I’d say as above that lack of ventilation is causing excess steam to condense in places other than the condenser. Test it in an open gap with plenty of ventilation.
Sent from mars
