[cab]

Re: Electrolux ER8034I (925771655) manual

no service manual available, fairly basic machine, all electro-mechanical, timer and stat. If fan aint coming on either it it goosed or wiring or timer.
cab

[cab]

Re: Zanussi WDJ1294 Dryer Fault

Hi looking at the diagram if you have eliminatated faulty stats and element everything goes thru the drier timer

cab

[cab]

Re: Hygena AHY8122

ther is a toc at the back pokes thru tub between element most likely that, if customer puts large pans over that area it stops the water taking heat away from element toc trips, early ones are manual reset.

cab

[cab]

Re: NEW ELECTROLUX HOB SMOKEY OR WHAT!!

If its a stainless hob they coat the under side with an oily coating many a service call on these, “Yes madam they all do that!”

cab

[cab]

Re: FISHER PAYKELL tech info

I have hard copy manuals what info do you need?

cab

[cab]

Re: AEG 72620 Drum support

hi been to a 72600 today making a scraping noise, at first I couldnt detect any movement in drum then I gave it a push up and it moved, took bearings off, they wernt too bad have ordered drum, bearings etc.

cab

[cab]

Re: Zanussi FL812

PART NO 50652604005 😕

CAB

[cab]

Re: Zanussi FL812

mickgeorge bang on the money.

cab

[cab]

Re: LG making strange noises

no any I have changed have just been the same
😥
cab

[cab]

Re: zanussi fx1465w

could be door lock if its not locking door, but most common thing I find is drain pump. the program styarts with a drain, if pump short circuit will cause board to blow.

cab

[cab]

Re: LG making strange noises

the belt drive versions have a rubbing from belt to crappy pulley, but the direct drive all do it on slow tumble, damned if I know what it is but they all do it.

cab

[cab]

Re: Zanussi frost free f/freezer ZX56/4SI

Hi have had a look on tds disc not much on there, but I have a feeling that there was a bulletin about a colder running stat, anyone else recall anything?

cab

[cab]

Re: LUX CHEST FREEZER CUTS OUT & LIGHTS FLASH

Hi have had loads of trouble with this type of control. might be the board itself, should display a fault. NTC sensor the red LED and the green LED blinking alternately, “-36” in the display, the compressor stops. If it is ntc dont think it can be repaired from memory its foamed into cabinet, but Electrolux have changed suppliers of certain board makes (about3-4 from memory) hope this helps 🙂

cab

[cab]

Re: hotpoint engineers cannot solder

Her Majesty’s what!

[cab]

Re: zanussi No Frost ZK87/34EF no go

Hi graeme,

have experienced probs with user control, Zanussi modified early ones, used to work for them 4-5 years ago. same S*** different day!!!

cab

[Author]

Posts