chezza

Forum Replies Created

Viewing 15 posts - 331 through 345 (of 457 total)
  • Author
    Posts
  • in reply to: Allen key screws – tamper proof ? #305975
    chezza
    Participant

    Re: Allen key screws – tamper proof ?

    cpc had a draper set recently, reduced 😆
    quite a few different tamper proof variants in it too . and lots of microwaves have them these days

    in reply to: AWO/D Whirlpool #297075
    chezza
    Participant

    Re: AWO/D Whirlpool

    iadom wrote:Just been to one of these today.

    12NC doesn’t even register on my copy of SIOS.
    8592 936 15205.

    Apparently just over 12 months old, main bearings completely shot, drum flopping up and down. 😥

    Anyone know the part number/price of a complete drum on these?

    part number is 4801 111 00133 , pricing info not available though 😆
    hope that helps

    in reply to: bosch wfo2864gb/01 #304954
    chezza
    Participant

    Re: bosch wfo2864gb/01

    Martin wrote:

    chezza wrote:
    Is there a translation facility on here anywhere ?

    I’m pretty sure I can translate here chezza. 😉

    adv wrote:this emtys spins but on wash cycle cuts owt after 15 mins an display goes out any clues guys?

    A quick megger test on the heater terminals well worth a look I reckon. 😀

    :popcorn: 😆

    in reply to: bosch wfo2864gb/01 #304952
    chezza
    Participant

    Re: bosch wfo2864gb/01

    Is there a translation facility on here anywhere ?

    in reply to: Hotpoint future FFA90 fridge freezer #304310
    chezza
    Participant

    Re: Hotpoint future FFA90 fridge freezer

    Thanks Twinspark,
    much appreciated 😆
    I’ll get a full defrost and see how it looks ( seal is ok, that much I was able to determine on the initial swift looksee )
    Eddie

    in reply to: The 0800 Thread #300944
    chezza
    Participant

    Re: 0800 Repair

    What a loss to Miele, they must be kicking themselves

    in reply to: Burnt out microwave #304219
    chezza
    Participant

    Re: Burnt out microwave

    Given the ” condition ” of the rest of the cavity, I think it is likely to be due to splashed food, which will continue to cook every time you reheat your coffee etc…anything with a high fat content ( cheese, butter etc etc ) will be worse than other bits but all will eventually do this

    in reply to: meggers #303341
    chezza
    Participant

    Re: meggers

    Also agree, and suggest others take advantage of the document martin has produced 😆

    in reply to: Whirlpool 20RB-D3L #303764
    chezza
    Participant

    Re: Whirlpool 20RB-D3L

    If you want it for ice and chilled water it does ( If you dont want these , just leave switched off and not plumbed in )

    in reply to: American Whirlpool fridge Fridge freezer ‘CF’ Error. #302678
    chezza
    Participant

    Re: American Whirlpool fridge Fridge freezer ‘CF’ Error.

    Also worth noting, now the cold weather is with us , if you are fitting the board first thing in the morning and it has been sat in your cold van overnight , this may affect the use / display until it reaches an ambient temperature

    in reply to: Flybe “airside” installs #302574
    chezza
    Participant

    Re: Flybe “airside” installs

    don wrote:
    Installing “airside” means fitters will have to complete a security / safety form allowing them to work in that area, which I`m told is just a formality.

    Don 🙂

    That is what they always say, truth is likely to be an awful lot different when you are trying to enter with toolbox etc . If it is anything like Newcastle airport, expect at least half a day messing around trying to get clearance on the day and as for parking close by………

    in reply to: whirlpool dishwasher #299848
    chezza
    Participant

    Re: whirlpool dishwasher

    goosegreen wrote:Check the grid on the water level s/w on the r/h side of the sump, May be crudded up and operating before the motor kicks in.


    Goose

    yep, had very similar last week . toothbrush ( use the wifes ! ) and kettle of boiling water 😆

    in reply to: ADG7560 weird fault #299673
    chezza
    Participant

    Re: ADG7560 weird fault

    Had similar on one today , and it was the fine gauze filters blocked ( but not obviously until you held up to light ) and this was affecting the OWI .

    in reply to: Whirlpool American Fridge Freezer broken down – help! #142348
    chezza
    Participant

    Re: Whirlpool American Fridge Freezer broken down – help!

    :popcorn:

    in reply to: Whirlpool American Fridge Freezer broken down – help! #142322
    chezza
    Participant

    Re: Whirlpool American Fridge Freezer broken down – help!

    I had a work colleague die via fatal electric shock working on a washing machine back in the eighties . a fully competent experienced service engineer .no 2nd chance or possibility of laughing that one off.
    and thanks for you ignorant racist view daddykool – albeit misguided to an englishman .

Viewing 15 posts - 331 through 345 (of 457 total)