Forum Replies Created
-
Posts
-
Re: Watch out for this scam.
Get one every year. Well worth the £900 odd quid if anyones washer breaks down when they’re on hols…not
Tony
Re: Which Smartphone ?
rolf wrote
Ive also found that I don’t take the paper to the bog anymore I just make sure i’ve got my phone.
Dunno Jim, probably softer than Izal :eeek:
Tony
Re: tesco advertising
Did a similar thing when I first started out. Didn’t make the money back even with the people setting it up doing a leaflet drop to help out further.
Tony
Re: First Choice Marshalls
Doh 😳
I thought this was a post on which amps should always be turned up to 11 😉Then again I did have a Marshalls get in touch for jobs but they didn’t leave an email with their address/ contact details. Don’t know if it’s the same people though.
TonyRe: CI555WH Spin Problem
OOps. Just seen this one. Had exactly the same fault last year. wire on the motor plug (lowest one IIRC) broken in the insulation.
Tony
Re: Bosch vented dryer. Is it a fault code
Cheers Martin. Funnily enough she mentioned it’s in the garage and has been playing up since the cold weather last year.
TonyRe: Howdens Kitchens
Jim, Can’t you have a word with Vancey boy. You’ve done him enough free advertising over’t years 😉
Tony
Re: Hoover classica E1
Helo wins the chocolate pig 😆 On both accounts 😳
Heater down to earth causing problems with the fill side.Tony
Re: Nothing to do……but.
funkyboogy wrote
no prizes for the nationality of the last 3 that went to bed .
Ale-banian by any chance 😉
TonyRe: Hotpoint Dryer – VTD00P
I might be on a different variant of this model 😳 but I’m sure I’ve had the interlock on these do the same thing. Usually relay behind the fascia between the top of the drum and the cabinet causes this fault though.
TonyRe: WML540 hot and cold fill?
She didn’t require my services in the end, so no more info than that really :con:
TonyRe: hotpoint wml540
Go the board back from EMW. Machine now works but not sure if its doing what it should. The clicking has gone but I was under the impression that when the pause is pressed, the programme stops and the door can be opened. You can change the programme but the original programme will not stop until you do so 😕
Also once the end light shows should the door remain locked. I’ve been powering it down, wait a few seconds, power back up press the start and …..the door unlocks.Plus…..PLUSSSSSS….i’ve never had to take the front panel off to swap an interlock before. I’m really beginning to dislike Indesit….no honestly 😉
Tony
