Forum Replies Created
-
Posts
-
Re: Repaircare asked me to work for them?
eastlmark wrote:to be honest, their system is very time consuming and if, like me, you only do the odd job for them, you never really get the hang of using it.
oops, 😳 read this as Repairtech…. ignore me! I think I really am loosing it.Re: Smeg SUK92CMX5 Clock
I defo wrote a reply but must have forgot to press submit or got distracted!
Re: Smeg SUK92CMX5 Clock
sure I answered this yesterday…..
only 4 wires on the clock it cannot be that difficult for an engineer to work it out. Need the check first its not a bad connection (terminal block or some have multi plugs in the loom that burn out) or the safety toc – look for signs of it melting or burning.Re: Neff D/W E15
most likely Jim, no obvious leak- recalls every 3 months for the next year till the heater goes pop and they give up.
E15 can also be a no or slow fill fault if there is no water in the base.Re: Miele Go Sealed!
some weird pricing going on at Miele, door seal 6579421 now £35 down from £70 odd.. £105 at connect
Re: Bosch dryer flashing ‘Container’
In a true Tim Downing shortcut way, the trap door can be accessed from the front once the condenser is out (easy once you see how it unclips) bit of kitchen roll to mop out the jelly, flush some water down to flush the stuff under the pump out and should be ok.
Re: NEFF S41M63N1GB Dishwasher Aborting Cycle
stick you meter on beep setting and set the machine to fill, if it goes beep beep beep……… then its fine.
Re: New machine dilemma !
smeghead wrote:
Martin wrote:
Save 300quid, buy a Bosch WAE28262GB. 1400rpm, split tub, brush motor, 2 yr warranty…..sorted!May be too late for Bosch as the other half has been to have a look & fancies the Miele.
Well who i am I to argue ?
Just a point , does the Miele have brush motors .?
Thanks.When she traps something in the door and rips a chunk out of the door seal lip, the £100 cost of the Miele seal will changer her mind.
Re: zanussi zdt6053 start button
photo might help id it. If its the usual soldered on button I usually steel one from an old board.
Re: bosch dishwasher e09
timdowning wrote:I always use the new jubilee clip!!
I always did the freestanding with the side off then I thought that as I do the integrated ones through the front why not that way on freestanding.
You disturb no connections / plumbing plus you can do a visual afterwards with the front panel still off.can you access the clip to tighten it from the front?
Re: Neff S41E50S0GB/28 E24 fault code
Best thing to do on these is to keep an old circ pump with a blown heater and use this as a slave. Connect up the slave pump motor plug and the NTC (obviously don’t plug in the heater) and try the machine to see if the error has cleared, if so its a faulty wash pump.
Re: WTA 2017 conference
kwatt wrote:I did wonder where you’d gotten to. 😉
K.
a good call for me in the end, spent the day and evening in Addenbrooks.
