eastlmark

Forum Replies Created

Viewing 15 posts - 151 through 165 (of 4,480 total)
  • Author
    Posts
  • in reply to: WTA 2017 conference #442025
    eastlmark
    Moderator

    Re: WTA 2017 conference

    sorry everyone, been unable to shake off a bad virus/infection so could not make it in the end. Reminds me as I was taken ill at last years meeting and did not want a repeat. Obviously a bad time of year for me these days.

    in reply to: Rangemaster induction 9743 #445439
    eastlmark
    Moderator

    Re: Rangemaster induction 9743

    no, not done the strip down yet. Was assuming the ring that flashed and the power board but the parts list is unclear and shows about 5 different pcbs in the box. I have quoted her best case scenario and worse case and if she still wants to proceed then I will take it a part. Looks very early smeg style range induction hob to me. Thanks for the info.

    in reply to: Qualtex Account Closure #443584
    eastlmark
    Moderator

    Re: Qualtex Account Closure

    seems its not just some customers getting the boot….

    Good afternoon

    Today is my last day at Qualtex due to redundancy.

    Many thanks for entrusting your business to me.

    It has been a pleasure working with you.

    in reply to: Zanussi cooker door catch #444838
    eastlmark
    Moderator

    Re: Zanussi cooker door catch

    not shown so have to assume its part of the door frame 561 04 37-06/2

    in reply to: Dsc85w It’s a BEKO. #444410
    eastlmark
    Moderator

    Re: Dsc85w

    maybe get a better response if you elaborate on make and what appliance this is, Its not obvious to me for one.

    in reply to: Siemens W/D spins on dry #444184
    eastlmark
    Moderator

    Re: Siemens W/D spins on dry

    model number is not recognised but suspect it maybe a smeg made one? these will spin on dry if the load is measured to be too wet for drying, will often also go into a spin when empty testing the drier.

    in reply to: De Detrich American style fridge freezer UN2587/UW1587 #368285
    eastlmark
    Moderator

    Re: De Detrich American style fridge freezer UN2587/UW1587

    thanks for the update…..

    in reply to: Dishwasher salt how many washes #444082
    eastlmark
    Moderator

    Re: Dishwasher salt how many washes

    depends on how/ if they have set the water softener up. In general most are left on default setting however hard the water is as we all know nobody bother reading instructions any more. If its set for hardest water setting then your estimate is about right.

    in reply to: Diplomat ADP8902 D/W #444031
    eastlmark
    Moderator

    Re: Diplomat ADP8902 D/W

    rocker wrote:This dishwasher has smeg parts fitted. It has a strange fault, on starting up the pump runs for some while, then it appears to fill a small amount of water, then resorts to pumping, stops then pumps again. (its not a flooded base)
    There is a protruding piece of plastic around 2inch high, near filters like use to be in the Bosch D/W with a sliding magnet, but can’t see anything inside it. !!
    any advice would be welcome. Thanks John

    sounds pretty much as it should, proper fill starts after about 4 minutes of this.

    in reply to: Qualtex Account Closure #443551
    eastlmark
    Moderator

    Re: Qualtex Account Closure

    those who have had their accounts closed might be interested in a thread in the WTA forum.

    in reply to: iwde126 door latch problem #443985
    eastlmark
    Moderator

    Re: iwde126 door latch problem

    sounds like the spring has not been fitted the right way around.

    in reply to: Wpool adg7560 heater #443981
    eastlmark
    Moderator

    Re: Wpool adg7560 heater

    deltra wrote:Hi, need a heater for this dishwasher but can’t find it. Should be circular unit that twist fits onto motor! Can only find a kit with a flow thru heater, is this a update!!

    yes a reverse update if you like!

    in reply to: Smeg DWF410SS dishwasher #443969
    eastlmark
    Moderator

    Re: Smeg DWF410SS dishwasher

    base comes off, hardly a strip down.

    in reply to: Hotpoint EDB710X cooker top oven stat #443927
    eastlmark
    Moderator

    Re: Hotpoint EDB710X cooker top oven stat

    C00199554 but obsolete

    in reply to: PAT tester damages Siemens dishwasher module? #443825
    eastlmark
    Moderator

    Re: PAT tester damages Siemens dishwasher module?

    The only useful part of a pat test is the earth bond test as it will pick up a poor earth connection which may only be one strand of a severed earth wire.
    Miele heater element earth faults for example will never show on any insulation test as they are wired direct from the terminal block via a double pole relay.

Viewing 15 posts - 151 through 165 (of 4,480 total)