Forum Replies Created
-
Posts
-
Re: SMEG SUK91MFX cooking unevenly
is the door closing tightly? worn hinges can leave a gap between the door and the seal causing a large heat loss which may cause this problem.
Re: Selector indicator broken on Neff U1552 Oven
good old Film strip, not cheap and an absolute swine to fit. would advise getting this job done by a pro. Also, take care you order the correct one as, if its a double oven, there are 4 fitted and they are all different. Not only that, if one has snapped the others may soon follow suite.
Re: Differences between self-employed and being an employee
blooming great tax bill to pay every July and January.
Re: Hydrocarbon disposal ?
subs wrote:Who recommends venting HFC’s etc to the outside then? This is illegal. The refrigerant must be recovered. Some refrigerents produce toxic fumes when burnt, so burning it off with a bunson burner is not a good idea. There is a course on the safe handling of refrigerants.
Subs
Subs, look at title of thread!
Re: Miele novotronic w526
leavemetogetonwithit wrote:According to exploded diag on Connect/mediator there should be one bolt below door seal bottom lip.
Mike.how long have connect had exploded Miele diagrams?
only a inlet hose stocked though!
Re: Miele novotronic w526
…and a screw each side under the kick plate. door seal off, and the front drops off.
Re: mysified
had this the other day on a whirlpool build in and was tearing my hair out over it. after changing all the drain hoses and the continer/air break at the back it turned out to be the filter! No not blocked, but broken. The customer had cleaned it recently and as it was stuck in, she forced it out, breaking the outer cage of the filter in the process which she just binned, replacing the filter without this. Must admit, even to me I couldnt see anything missing as some filters are just simple ‘mushroom’ shape anyway. As this one did not form the seal around the pump impellor there was no pumping action at all, the impellor just spun around uselessly splashing the water around inside. Might be worth a closer look at the filter in your case, adv
Re: smegg dw
adv wrote:mmmm didnt thing a soapdispenser wud cause so meny problems on these dishwashers. why does it ?it wont be called to operate til water starts to heat up naw? :rolls:
dont ask, just try it!
Re: smegg dw
as we always tell folks, first thing to look at is the dispenser, just connect up a solonoid valve coil if you dont have a dispenser to hand and at least eliminate that one which causes all sorts or odd faults. everything else you can test wihh a meter and if all seems ok and no leaks then it will be the PCB. Filling and emptying together for the first few minutes is normal.
Re: ISE10 Washer – Door does not lock
very common fault on a Miele, by the way! and cured the same way.
