Forum Replies Created
-
Posts
-
Re: Miele W864 FL elemnt O/C
Seamy wrote:Can’t pressure system can be re calibrated in servie mode?
more on this please?
Re: Miele W864 FL elemnt O/C
I believe, with the right equipment and software it can be re-callibrated using a laptop. Had a few like this, if you have a blocked air pressure chamber, always check the level afterwards, it barely covers the bottom of the drum when this fault occurs.
Re: Still looking for washing machines for Recon!
If you post your rough area I am sure those with stuff to get rid off will contact you.
Re: Hotpoint DF53 leak.
cannot say if its your problem or not but 31×9459 is a whole lot cheaper and will fit that model.
Re: hotpoint BFi670 configure
Not only a diswasher but a built in one! Never have guessed really 😆 Bradley, I think they are trying to say there is an edge connector missing on the board you have just fitted that needs swopping from the old board to the new one.
Re: ISE 10 T/D
Steven, cannot think of any way the hose can be fitted and water still fills the container.
ps what does C/x mean?Re: ASKO 20004 – Please help with unknown error
sorry for the delay in replying…. no easy answer to that one, assuming the parts replaced have been fitted correctly. Some of these have a door release relay that give it the delay before the door is allowed to open. I do not have a wiring diagram (there should be one inside your machine assuming the other engineers have not taken it) to see it that could affect the motor action. This part is not on the door lock, its mounted on top of the drum along with the pressure swtich and relay. Sorry cannot be much more help.
Re: ISE 10 T/D
It is in the instruction book, did you net even get one of those? Its simple, pull off the short loop hose at the top of the back panel from the connector nearest the side panel, leave that hose dangling and fit the supplied extension hose to the connector where the other hose had just been.
Re: smart card indesit
no, you dont need a laptop (if only!). You ned to buy the software in the form of a smart card for each model variant as and when you need it, and not, they cannot be used more that once. AFAICT, the smart cards are marginaly cheaper than the old EEproms but a lot less fiddly to fit. Only done one myself as yet though. there is a whole thread on this subject here. Just the reader will do until you come across one of the low end models that doesnt have the board at the back when you need to use both.
Re: Yell.Com
Alex wrote:
eastlmark wrote:
Call me old fashioned but we still have our landline in the hall and yes the directories are stacked underneath it.Goodness me, would that be between the Aspidistra and the Umbrella stand?
Alex
are your saying I am old fashioned and stcuk in the 70’s? At least I am not getting excited by the latest Queen CD 😆
