Forum Replies Created
-
Posts
-
Re: Liebherr CUNesf3913 problem
hello giles, the freezer sensor is the same part number as the fridge one – 9590142 and on this model you have 2 pcbs, display pcb is 6143042 and main pcb is 6143110.
have you changed the fridge evaporator one?Re: Liebherr CUNesf3913 problem
With the intermittent nature of your fault, it’s likely to be a sensor issue, but I’d also be checking the condition of the freezer evaporator just to make sure you didn’t have a blocked drain hole.
If that was ok, then I’d be looking at the fridge evaporator sensor 9590142.
Obviously the job isn’t so simple that I can just sit here and diagnose without seeing the appliance, but that’s the more likely scenario.
Other causes of your problem could be the freezer evaporator sensor or even the pcb.Cheers.
Re: Liebherr standalone Fridge problem
Hello, just seen this. As Ken rightly says, your problem is likely to be the compressor. 90 odd percent of the time, a clicking starting device is a direct indication of the condition of the compressor.
Check your pms.Cheers.
Re: liebherr GNP3376 evaporator
hello, you wont get a fault code for the sensor unless the sensor goes open circuit, in which case you’d get F4 on the display.
the sensor is the most likely option, given what you’re experiencing.
the part number you require is 9590148.
it’s an easy fix, done inside the cabinet using heat shrink material.
hope that helps.Re: liebherr CL 1650 ice maker not making ice
hello again dietmar. the magnet is on the icebin that collects the ice when it has been dropped out of the icemaker tray.
it is found on the top of the bin in the middle.Re: liebherr CL 1650 ice maker not making ice
Dietmar, the arm is normally in the up position. At the beginning of the harvesting process, the arm comes down and then goes back up. It comes down to check the amount of ice in the bin.
If the arm can’t fully travel all the way down, then no ice is harvested.
Is the magnet in place in the top of the ice bin? The icemaker needs the magnet in order to harvest ice.Re: Liebherr CUN3033 Freezer not cold enough
Hi Pete, hopefully your problem was caused by nothing more than a blocked evaporator drain hole.
If the problem occurs again, then you do indeed need to be checking the defrost circuitRe: Liebherr CUN3033 Freezer not cold enough
Hi Pete, I’d check behind the back panel in the freezer to see if there was an ice build up on the evaporator.
That or the freezer evaporator fan not working is the likely source of a problem.Cheers.
Re: Liebherr CNesf 5013 fridge freezer: freezer high temps
Hello sorry, just seen this. It does sound like you have a system fault here. that is, a fault with either the compressor or the refrigerant level in the system.
Compressor replacement is a specialist job and is beyond the capabilities of the diy repairer, if only for the equipment needed to complete the job.Re: Miele K8452S Fridge
hello neil, this is an error code. its the appliances way of telling you that there is a fault with the sensor.
did you follow the instructions to fit the sensor correctly?
id be inclined to think that there is an issue with the fitting of the new sensor.Re: Liebherr CBNes 5067: how to replace defrost heater?
You should be able to hear it come on when you close the freezer door, or you’ll be able to watch it slow down when you open the door.
Cheers.
