[electrofix]

all i can suggest is contact hotpoint spares direct and see what they say

Dave

https://www.hotpoint.co.uk/spare-parts

[electrofix]

yes its not unusual to feed the control panel from one of the induction board
so if that fails it all goes off

Dave

[electrofix]

well you could try running it without the run capacitor winding in circuit and see what happens

after that am at a bit of a loss what to try

Dave

[electrofix]

looks good

Dave

[electrofix]

ok check the oven selector switch for burnt wires or contacts

Dave

[electrofix]

if your unit has a clock oven wont work until clock is set

Dave

[electrofix]

if the impellor fell off you will need a new pump as it wont last

this one should sort it

https://shop.ukwhitegoods.co.uk/1740301000-beko-other-dishwasher-drain-pump

Dave

[electrofix]

all the clicks are is the relays dropping out as the power fails

you may have a voltage on the board but chips wont work on high voltages so the power supply produces low voltage for the logic circuits

Dave

[electrofix]

sounds like a main pcb power supply problem

Dave

[electrofix]

remove pump and check for debris

you can do thie from the front through the cover at the bottom

the pump has a latch and you have to find and release the latch to allow pump to turn and unlock

you must drain and mop all water from inside before you start

Dave

this is view from underneath in pic 1 you can see him unlocking the latch

[electrofix]

Aswo are brilliant
stock is excellent and even has triacs relays and lots of electronic components , memory pens etc

lots of helpful tech really really good on vestel machines

Dave

[electrofix]

that does sound like a board or software fault

assume you have tried unplugging again, waiting 30 secs or so and plugging back in

Dave

[electrofix]

just for your ref

Aswo can supply configured boards

Dave

[electrofix]

well in that case nuts and bolts are your only option as siemans want £145 for a door

you could also try ebay for a used one

Dave

[electrofix]

yes its a complete door
but if its only the head of the rivet that off the stud has a hole in the middle. find the right size self tapper and you can sometimes fix it

Dave

[Author]

Posts