Forum Replies Created
-
AuthorPosts
-
electrofix
Moderatorthere is a relay on the motor
https://shop.ukwhitegoods.co.uk/5736330200-fridge-compressor-starting-relay
if its not that will be a failed compressor
Dave
electrofix
Moderatorfault 4 heater fault
Electra built by Vestel
All service manuals are on ASWO
Dave
electrofix
Moderatorwell google search seems to point to board communication problems
poss loose connections
Dave
electrofix
Moderator1st check the socket. try another one as they often go faulty
next up would be possible door lock failure
Dave
electrofix
Moderatorwell if the pump is running you either have a problem with the float sw or a shorted triac on the board
Dave
electrofix
Moderatordid you check timer for blown components ?
Dave
electrofix
Moderatorif it happened when the door opened i would suspect the wires that feed the door electronics.
it will enter at top or bottom hinge
that may have blown more than the wires but you need to check
Dave
electrofix
Moderatorwell according to the Siemans E23 is flooded base as expected but as you say this machine is not fitted with it.
the ciruit to the flood switch can either be open circuit thats closed when flooded or closed circuit that open when flooded
so
the only thing i can thing of is all machines have this facility and to stop it coming up on machines without they may short out the connector with a wire link
or if the opposite is true the connector has been contaminated with a leak shorting the plug to cause the error
Dave
electrofix
Moderatorgo to
put in commercial code and find appliance
then you get 2 different hopper tops. there seem to be a difference in the pics.
the one thats available is in stock at connectDave
electrofix
Moderatorhave you tried the reset sequence ?
Dave
May 10, 2024 at 12:20 am in reply to: beko excellence WMB91242LC no data shown for programmes #490239electrofix
ModeratorAortic Mark wrote:Thanks for ruling everything else out for me. I’ll take the plunge and let you know how I get on.
Regards.
Mark.well have ruled out all i can think of but you can never be 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} till you fit thr new board
Dave
electrofix
Moderatoroh well was worth a try
sounds like it may be a board failure
Dave
electrofix
Moderator[USER=”125″]don[/USER]
you any ideas con this Don
Dave
electrofix
Moderatorthis will probably replace it but to get pilot light to work you may have to add a jumper
https://shop.ukwhitegoods.co.uk/cs29…ergy-regulator
you will also need this
https://www.ukwhitegoods.co.uk/forum…ring-reference
Daveelectrofix
Moderatorwell you could rub it down, treat the rust then find a high temp paint of a similar colour
Dave
-
AuthorPosts
