Forum Replies Created
-
Posts
-
Re: Dishwasher only working on rinse or soak.
there seems to be 2 different boards depending on serial number. the wholesaler I looked at quoted a retail price of about £60 plus vat but it may well be got cheaper. plus fitting if you cant do it yourself
you could ask the site shop to see if they can supply
Dave
Re: Beko washer not spinning properly
at the back of the motor is a little generator called a tacho. its job is to tell the electronics what the speed the motor is so it can control it.
this unit is at the rear of the motor and consists of a coil with a magnet in the middle that is attached to the armature. my guess is the magnet has broken and is not turning so the module thinks the motor is not moving and keeps accelerating it
if it is broken its a new motor
Dave
Re: Neff S51L58X1GB/35 dishwasher PCB blown
you can never rule out condensation in boards that are mounted at the bottom of the machine especially in old cold property
Dave
Re: Neff S51L58X1GB/35 dishwasher PCB blown
looking at that i would guess possible water damage
none of the track seem to lead out to any component and if they did and that components had failed i would expect 1 or 2 blown tracks but you have had a full blown fire in one place
dave
Re: CDA WC600/1 dishwasher spray parts.
connect show Wc600 but not wc600/1
looked on Beko and cant find any ref
try ringing CDA most times their parts direct are cheaper than connect
Dave
Re: Indesit WIL133 Program Knob doesn’t match Programs
first thing to try is
unplug and take lid off. there is a ribbon cable connecting the top and bottom boards. unplug this cable and plug it back on about 3 times to clean contacts to make sure its got a good connection
the cable also connects to the lower board and if doing this at the top fails to cure it try same thing again on the bottom board
Dave
Re: Error codes
not much you can do as long as you clean filters properly and make sure vent hose is clear and straight
Dave
Re: Bosch WTV 74307GB/07 Door lock Fitting
I think if its the same as other bosch tumble dryers you have to take off the left side
to do that normally. Remove lid and right side, undo control panel. remove all screws holding left side. and remove ( don’t forget screw underneath )
not sure what you have to loosen to remove lock but above gets you 90{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} thereDave
Re: Dishwasher only working on rinse or soak.
that does sound a bit like a possible circuit board problem
Dave
Re: Indesit WIL133 Program Knob doesn’t match Programs
do you get the same programme no matter where the knob is ?
Dave
Re: AEG L74620 not filling
the draw top do go. when they do you hear a clunk, clunk noise as the gears slip
Dave
