[electrofix]

Re: Lamona dishwasher LAM8601 error message

have sent you a few files

Dave

[electrofix]

Re: Neff H5972N0GB/01 microwave

these units are based on the Panasonic design using an invertor and magnetron. the unit detects if the mag has energised properly and if it does not it will abort the programme. Normally after 10 to 15 secs. it is likely that when the unit aborts it goes into the cool down mode.
with your fault, if the microwave fuse is ok it is likely to be the mag ( but I cant promise ) . look at the magnets to see if one of them is damaged
unfortunately you cannot be certain of the invertor until you put a new mag in

Dave

[electrofix]

Re: Logik Cooker Hood

no idea if it will fot but if you fit an outside vent cover with flaps on it it should stop reverse flow

Dave

[electrofix]

Re: Whirlpool ADG7550 Dishwasher

have a close look at the filter. if gauze is blocked it does this

also hose does not have to be blocked just partially obstructed at the sump

Dave

[electrofix]

Re: Logik Cooker Hood

Getting info for logic products is about as easy as getting an audience with the pope.

what is wrong with the flap as they seldom fail. there job is to stop air coming back the other way so unless it is vented to outside its not really needed

Dave

[electrofix]

Re: Electrolux electric oven not working

I would have a good look at the contacts on the switch behind the left hand knob. sounds like a contact has burnt out

think you may find the thermostat you have turns the fan on so should be open until it gets hot

Dave

[electrofix]

Re: Connecting Strip requiredi

not sure what you mean by connecting strip

Neff spare part diagrams are here
http://www.neff.co.uk/store/spare-parts

if you cant see what you need ring Neff spares on 0344 892 8989

Dave

[electrofix]

Re: Random magnet found in Siemens washer.

Ken sound like he is bang on look at the picture of the motor I have added

magnet should be under the cover indicated.

it should not be loose enough to fall off so if its not damaged put a little glue onto it as you put it back. use something like Evostik or bostik not superglue as you have more time to get it positioned and you wont stick your fingers together. let it dry before you start to use it for washing

if the magnet is not there the motor speed will be uncontrollable so the unit will spin on wash

Dave

[electrofix]

Re: Aqualtis Auto dose issue

well spotted Don

but I would like to know why and what he hopes to gain.

does not make a lot of sense

Dave

[electrofix]

Re: Miele W 2241 – First use – Flashing Rinse light

thought it may be a drain problem but No

Miele will know how old the machine is so try ringing them and ask

when you ring have the model and serial to hand in case they ask

Dave

[electrofix]

Re: Whirlpool AWZ514D

cannot confirm fault code but ntc faults can come and go with ambient temp. Have had repairs where machine would start if you poured a pan of hot water in first

Dave

[electrofix]

Re: Electrolux d/w ZDT12011FA fault codes

sorted

check your pm

Dave

[electrofix]

Re: Miele W 2241 – First use – Flashing Rinse light

did it empty ?

where is the drain pipe plumbed into ?

Dave

[electrofix]

Re: Electrolux D/W

yours seems to be the mechanical timer. watch it fill and closely watch the timer. does the timer knob try to move forward and then click back and carry on filling ?

Dave

have pm’ed you the manual in case it helps

Dave

[electrofix]

Re: LG WM-1090FHB Switch

how about posting a picture of the switch

Dave

[Author]

Posts