Forum Replies Created
-
Posts
-
Re: Zanussi ZDT12011FA water in base
what was the last reported error code ?
is it overfilling this unit has a mod on the pressure switch
Dave
Re: Reactive Insurance Solutions Ltd.
just a quick search and i found a previous name
SATELLITE & HOME CARE LIMITED
now a dormant company but one man said his 85 year old mother was ripped off by them
https://beta.companieshouse.gov.uk/company/06787818
http://whocallsme.com/Phone-Number.aspx/08003288022
Dave
Re: Beko wmb714422w no spin & e11
have you checked the dc board from memory its just a bridge rectifier on a pcb
Dave
Re: Whirlpool AWO/D 6528 Dead
they just sell the boards and expect the person ordering it to be able to fit it. you need to check the board is preconfigured
cant be certain but most board configured or not will give some lights. are you certain you have both live and neutral at the blue connector ?
you could open old board and check that resistor. if the resistor has blown I would also change the power supply chip which is a small 7 leg chip. not sure which chip is fitted to this module but look up lnk364pn on Google it will give you an idea what your looking for. changes lots of these common fault on lots of units today
Dave
Re: Miele W310 motor access
door boot off
screw at door lock off
kick strip off
screws holding front panel at the bottom off
large screw at bottom of door port hole offprovided I have not forgot anything after that its just clipped on
Dave
Re: Whirlpool AWO/D 6528 Dead
if you connect mains direct to the board on the blue connector it should light. try it with the old board first
would not be the first time I got faulty boards from connect
Dave
Re: aeg t356850 prod916095202 00
does it cut out or is it failing to reverse. bought an AEG of Ebay last year with similar fault ended up being bad relay solder joint on pcb
Dave
Re: Whirlpool ADG7550 Dishwasher
have a closer look had a similar problem and found a piece of glass which was hard to see till I looked closer. when you think the only reason the hose is closing over is a vacuum problem. if there is no restriction it should not happen unless the hose has lost integrity
dave
