Forum Replies Created
-
Posts
-
Re: Bosch wvd 24460gb/04 f 18 dry side
a lot of later machine do not start the water till its hot. assume its measuring an ntc or maybe waiting for moisture (steam)
had a similar fault with a CDA machine but found if I set dryer and started it, then switched off at the socket, waited till all went off and turned back on. the machine started where it left off but the water was now flowing
dave
Re: Neff U1451N0GB Fan Element (New) Not Heating
if an element is going to work it needs 220v but it also needs 0 volts
if both connections are fed 220v it wont worklooks like you are short of a neutral
Dave
Re: Hygena APP 6302 erratic temperature
also never assume the new stat is ok. would not be the first time I got a faulty new part
also you should be able to check if the compressor is being supplied but not starting. one tell tale is a click every now and then as the cut out pops out when the motor fails to startDave
Re: What to the three ports on the water inlet valve do?
if its a washer dryer third valve is used to condense steam
dave
Re: Zanussi F1045W
no probs m8
pity you got the timer before you found out although they may take it back
Dave
Re: AEG OKO_Lavamat 6100 digitronic
if you look at the drum does it look like its out of true when you turn it ?
Dave
Re: Miele W5298WPS
not sure which relay you are talking about but for any of these machines to work there has to be a low voltage power supply feeding the board. you need to find this and check it
Dave
Re: WTA 2017 conference
was looking to come and see what goes on but site says WTA personnel sold out. since i don’t know how the conference works i dont know if i have left it too late to make it worthwhile to come
Dave
Re: zdt12911fa sensor kit
for some reason cant find that model or part number is it correct ?
what is the PNC ?
Dave
Re: Indesit IWDE 126 – Red Door Lock Flashing will not unloc
sounds like you have broken the door handle
Dave
