Forum Replies Created
-
Posts
-
Re: Return to work
i am sure I am not alone in this forum in wishing you well for 2017 and your forthcoming enterprise. I will always help where i think i can but a search of past post can bring up a lot of answers without the need to post
All i can say is if you need help ask and we will see what we can do
all the best
Dave
Re: Fisher & paykel
when you say not draining properly it sounds like its trying but not making it in time
if so make sure the tube into the pump is clear and a few blocked ones. just need to rod it through with a piece of 3 core flex
Dave
Re: Hotpoint EDB710X cooker top oven stat
yes kenn i got the same question Hotpoint ??
part no i get is 506008433001
Dave
have pm’ed you wiring of the cooker
Re: LG WM14225FD motor issues.
qualtex list 2 against that model
4417EA1002D & 4417EA1002W
the fault you are describing is a 3 phase motor with only 2 phases working so it could also be the board
Dave
Re: Hotpoint weight retaining springs
poss similar to this post
Dave
Re: Candy Tumble Dryer not heating
i would recheck the rear stats. on the candy if the overheat stat trips it will not reset and you have to change the element
Dave
hkRe: CDW Dishwasher – door latch won’t lock
does the door seem to be hard to close the last 20mm or so
check the baskets. is the top one all the way back. sometimes as the rails wear the basket is not quite inline and does not go all the way in
the bottom basket will only fit 1 way round
Dave
Re: hotpoint dryer cdn7000 trips fuse box
its a condensor dryer so i would guess water is the problem
unplug it !!
turn the unit around and remove the heater box. if water trickles out thats you problem. it can get in the heater box if you dont empty the water and it overfills
Dave
Re: Naff Oven Lamp Holder
well it might be
it pushes in the way and metal clips spring out to hold it. you should be able to bend those clips from inside the oven and withdraw it
poss bad news i dont know how long the cables are so once it is released you have to pull it through enough to disconnect and reconnect the new one
if you need to get it out best way is a black and decker workmate. then you have a secure surface to take the back off and change it and you dont have to lift it down to the floor. also there may not be enough cable on it to do this
Dave
Re: Bosch SGV57T03GB/02 dishwasher not filling
check you have the wiring back on the metering unit microswitches. double check the pressure switch is in the empty position.
check wiring from Valve and microswitches to the timer in the door
open the timer and look for blown triacs
Dave
Re: Bendix BTD03 91609204801
reading between the lines they say its to make the drum easier to turn could mean they had been getting belt failures or unit wont start due to too much friction
Dave
Re: Bendix BTD03 91609204801
interesting one this one
will pm you 2 docs from an earlier model namely 916092048 00
they list a mod to change the front seal and add the skates
old seal part no 125 00 28-05/5 new seal part no 125 05 87-00/1
and they seeed to have made the new seal obsolete but you can fit the earlier one without the skates
but from the other doc they made a kit to repair earlier units 50272165007 and connect have stock
Dave
