Forum Replies Created
-
Posts
-
Re: bosch not heating up .
make sure that when you test it you have wet washing in it. most dryers dont turn on the heat till they detect moist washing
Dave
Re: not cleanig
check drain have had a few like this when plumbing allowed dirty water from sink to back fill dishwasher
Dave
Re: Bosch logixx dishwasher. Model SGS65L22GB/07 Pump Probl
the pump is behind the impellor. these pumps do fail but normally they don’t start so all the water is left in. common fault is glass sticking the impellor which can be awkward to remove as you cant see them
Dave
Re: Smeg oven blown element?
element is taken out from inside but on some smeg elements you have to get to the back to undo the holding nuts
Dave
Re: Bosch Single Oven HBA43B2- timer failure
this is not the complete model number
go here
http://www.bosch-home.co.uk/store/spareparts/search
put in complete Enr and you will get a list of spares
from what you say it may be the whole clock
dave
Re: miele ws5073 dump valve
ring miele wont be cheap but at least you will get it quick
it may not be the whole valve as some parts may be separate. look at the part that’s gone as miele normally put their part numbers on them
Dave
Re: beko 71442 – door locked but doing nothing
switch off for 5 mins
open door and see if there is water still in machineif yes sounds clike pump blocked, clear filter and try again
Dave
Re: Should my dryer get this hot?
just to be safe side ring the bosch customer service and ask.
Dave
Re: Indesit 1S70C
as with most dryers there are very few components
no heat can be
faulty element
faulty thermostats
faulty timer or pcb
faulty wiring (burnt out connections etc )
DaveRe: Bosch Exxcel Aquastar – E:24 error drain route is clear
in a word yes. on this model they sense the current drawn by the pump motor to detect if its empty. so if the pump is worn it draws more current and fools the electronics
Dave
Re: Smeg DWI612C E3 error
fill it and feel the pipe at the back to see if its warm. if yes then you know where the heat is coming from
after that it getts difficult you have to check all the components above
Dave
Re: bush f721qb door seal
bit of a pig to find spares for
most likley a Vestel machine
qualtex list 2 Vestel boots part no 42002568 & 42024953also when you type in bush you get link to a haier machine boot mfi part no 200014410200
think what i would do first is ask connect if they have a boot for it and then see if any of the above numbers bring up the same part
have you emailed site shop to see if they can source ?
Dave
