Forum Replies Created
-
Posts
-
Re: Hotpoint oven – model BU72P
most times you can get from the front just take care when pulling terms through that they dont pull off
Dave
Re: Zanussi FLE1215W Washer – 3 beeps but no action
you need to access diagnostics if you can to read fault code
let me have you email will, send you some light reading
Dave
Re: LG PCB repair?
is there a voltage on the cap
hope this helps
Dave
if its 430volt
there are 10 caps on this site fron £5.50 just need to check sizes
Re: hoover hnwl7146 washer dryer
are you setting dryer to a time or does machine have an auto sense and defaults to 60 mins on start up and reduces when no moisture detected
just a thought
Dave
Re: Hotpoint WT741 thermistor
heater not a bad price but if you want to wait till next week got to change a heater due to earth fault will send you the thermistor
DaveRe: AEG lavamat 62820 What is a “barrel ring”?
worst thing about ships is a lot of them use 60hz and out parts dont like it
Dave
Re: Candy CDC266 Dryer
when filter light comes on normally the sensor stats on the element
sounds like element will need replacing soon cant buy stats on their own
Dave
Re: LG PCB repair?
not a lot u can do unless you can get board out of jelly
but look at it this way if the customer is in agreement you have nothing to loose if you can get at the solder joints even by cutting a hole in the plastic frame then you can replace it
hope this helps
Dave
Re: miele dryer
to continue from washermanuk’s comments
a lot of dryers these days sense the moiture in the clothes and turn off when dry to save energy
either put some wet clothes in to try or look to see if there is a timed feature to turn dryer on for 20mins or so this normally does not use sensors so wont switch off
hope this helps
Dave
Re: belling free standing cooker
dont know this model but
assume you are talking ceramic ring and not halogen
most elements either work or they dont so most likely to be control use a multimeter and test ring
if it is a single circuit plate you could swop live on controllers to see if fault moves to another plate
if a simmerstat is used make sure you have a quiet room. turn cooker on and listen closely for simmerstat going in and out you will probably get a buzz from ring as it is powerered up. on full power the simmerstat will not click on and off
hope this helps
Dave
Re: waste disposals
they never suck the stuff down no air flow to do it
gravity lets stuff drop in then it gets mashed up and rinses away
only had problems when motor unit not working
Dave
Re: creda s150e
its a disconnect and try job
as deltra said
disconnect all elements
make sure all wires are clear
turn on see if it trips
if not reconnect each element in turn till it tripsdont forget the houhold trip goes out at 30ma but that not on the appliance you are on it is a cumulative figure for the whole house
so if the rest of the house is leaking 20ma you only need 10ma to trip and that 23K to earth. also if you are using a 9v meter it may not show up at allhope this helps
Dave
Re: HOOVER HNMF
dont repair fridges but what gias said sounds about right
have talked to many engineers who have to cut a hole in the insulation attach thermistor and reseal also re-routing wires to connect up
mad i know but the thermistors are put in before case is sealing in manufacture
hope this helps
Dave
