[electrofix]

Re: Large Whirlpool American Dryer.

if you take stat out and tap it on the floor it will reset but check airflow before you do had one where hot air was recirculating into case and tripping stat

easy to get to although you have to lie on the floor nothing new there

dave

[electrofix]

Re: hotpoint washing machine

drop it in very hot water and watch for bubbles that will tell you

Dave

[electrofix]

Re: creda 37654g

just found that out never checked will know for next time

thanks again for help

Dave

[electrofix]

Re: servis washer dryer – soap drawer

this soap draw is opearated by tharmal actuators the same design as the door locks these are switched by small triacs on the pcb if these do not operate then the water will go to the wrong compartment

had one recently where the traic had shorted keeping actualtor open permanently

take lid off and check operation look for both on and off state at various times of the programme

hope this helps

Dave

[electrofix]

Re: TDS Disc

i rang lux direct got it from them

Dave

[electrofix]

Re: creda 37654g

sorted customer happy many thanks

Dave

[electrofix]

Re: creda 37654g

my mistake thought you would have pm me got diag will see if it works thanks

Dave

[electrofix]

Re: Samsung B1245S Wash M/c Door Handle – Supplier Please

try message to r600a he recently got me a part for a samung freezer he may have contacts

Dave

[electrofix]

Re: T/BDX DOOR SEAL

124016742 /7

same as qulatex dbt75

from lux disk

hope this helps

Dave

[electrofix]

Re: creda 37654g

thanks awaiting mail

[electrofix]

Re: creda 37654g

still hoping someone may have a diag for this somewhere

does anyone know if the manuals are still avail from hotperloni

[electrofix]

Re: belling cooker door seal

type xou170 in qualtex and came up with

door glass inner seal part no 82605152 their stock code 613577

hope helps

Dave

[electrofix]

Re: Delonghi MW865 Microwave no micro function

dont know this one of hand but am assuming you only blow the fuse when micro starts ie you set time and push start button

disconnect mag disconnect diod disconnect wire from transformer ht
make sure these cant touch anything

turn on try microwave if blows is transformer

if not switch off reconnect capacitor try again if works again DISCHARGE!!! and reconnect diode and so on this is the way i find hv faults that will not show on meters

hope this helps but be carefull without the mag in circuit you will be left with a full charge on the cap

Dave

[electrofix]

Re: Bosch Maxx WFO2466 sticking on programme

WFO2466 gb /07 fd 8501 608094

have just had a customer complaining of a similar fault

machine stops counting dawn and stops with 1 minute to go but if you do a seperate spin or rinse machine finishes ok

checked all sump hoses and pressure chamber

now machine is over filling and overfill kicks in in pressure switch and lowers water

pressure switch buzzes out ok removed and replaced all connection to pressure sw and pcb had pcb off looked for track damage and bad joint no change

come to the conclusion programmer faulty

machine was 2 years old in feb

anyone got any more ideas ?

many thanks

Dave

[electrofix]

Re: Indesit Domed Torx Pulley Bolts

not only do they use locktite but from memory the back of the bolt head is grooved to lock in the alloy pulley

hit it first i say am always wary of slipping on this machine after a torx bit snapped and i ended up with 4 stitches to proove it

dave

[Author]

Posts