[electrofix]

by the look of it this is a self defrost unit

sometimes they get blocked with ice and the only answer is a total defrost

switch off , door open , 2 days

then see how it goes

Dave

[electrofix]

whats the Enr number ? and FD number

Dave

[electrofix]

toc is rivetted to the mica. the chances of drilling steel rivet off mica are close to zero and then try getting rivets back

you cant buy the stat, complete heater only

but beware there is a service bulletin about fitting the heater and fitting will need email to send it to you if you want

Dave

[electrofix]

coffee or clean water ?

Dave

[electrofix]

sometimes the use narrow tracks on board that blow like fuses

some boards do use fuses but in reality i can see it with this component

Dave

[electrofix]

Nxp Triac – 102h6d Triac, 600v 0,2a, Smd Soic-8 [Nxp] – £4.99 : Spares2Repair

[electrofix]

ran out of idea myself as you seemed to have checked it all

if its a board fault it starts getting expensive

Dave

[electrofix]

bekodonegood wrote:I’m away from home at the moment, so can’t test the switch. Is the procedure for testing a 2 terminal switch the same as you described previously ?

yes continuity when released open circuit when closed
but your saying lamp goes on and off so cant see switch being a problem. before with the 3 term switch was hoping half the switch was faulty

on the 3 position one one wire is feed and the other 2, one fior lamp and one for fan

Dave

[electrofix]

had a neff hob doing silly thing and it turned out to be blown cap on control board

very cheap easy fix

Dave

[electrofix]

for my job not heard anthing from customer so can only assume still no leaks

as for the box there is no obvious reason for the leak but changing box cures it

Dave

[electrofix]

think i found a service manual and emailed it

Dave

[electrofix]

there is lots of posts around on this subject

https://www.ukwhitegoods.co.uk/forums/forum/public-support-forums/help-and-support/fridge-and-freezer-forum/886456-hotpoint-fridge-freezer-compressor-often-running-compared-to-our-old-one-normal

Dave

[electrofix]

they do look pretty universal

since i assume you swopped element you can check old NTC against new one

had a beko short an NTC out and it blew a resistor on the board so you could chack for that

you can check continuity back to board

Dave

[electrofix]

sounds like the lamp went pop

poss blew a hole in the main timer

may be able to be repaired but call neff out and its a £200 board

Dave

[electrofix]

all manuals and teat routines are on aswo

but you will need the long serial no to get correct one as there are lots with same model

are you sure parts are correct ?

there are over 40 variants of this model

Dave

[Author]

Posts