Forum Replies Created
-
AuthorPosts
-
electrofix
Moderatorout of balance error by the looks of it
sent you the tech
Dave
electrofix
ModeratorHi Graham
check your email sent you the manual
Dave
electrofix
Moderatorprobably correct
if green resistor has gone its most likely the power chipproblem with these power supplies is they are always on so yours has been on since 2010 unleaa you turn it off at the socket
Dave
electrofix
Moderatorthe heat pump is used as a virtual sensor. if the old motor is worn it will give a different current profile and stop the heater being energised
still done think the odd ohm would stop it heating
Dave
electrofix
Moderatorseem to remember a tech bulletin somewhere thats says the belt must fitted in a position where it avoids screws in the drum as it revolves otherwise it wears out
Dave
electrofix
Moderatorwell if it is fault 5 it sort of fits
fault 5 is pressure sw
Dave
electrofix
Moderatoryou should be able to trace wires from the board and the door sw but since my wiring diagrams are wrong i cant be certain where they go to
Dave
July 19, 2023 at 9:37 pm in reply to: IWDC65125 all lights flashing but machine works when dryer element disconnected #487628electrofix
Moderatorthink that maybe fault 15
poss dryer relay open circuit
Daveelectrofix
Moderatorone of your problems now is a lot of the good manufacturers have stopped making vented dryers
of the bigger makes you have
hotpoint / indesit with a very weak rear bearing thats prone to failure
hoover candy which has the worst access of any dryer i know to repair if things go wrong and is now a chinese owned company
Dave
electrofix
Moderatorone of our suppliers list C00311051
as one that may fit. you would need to get your gas safe engineer to check its got the correct fittings and connections
Dave
electrofix
Moderatorkaibart wrote:Just you can only use programmed module as it need programming with bosch equipment part number you need is 00647251
and if you get this where does the correct software come from ?
Dave
electrofix
Moderatorany unprogrammed board would need access to a programmer and the revlavent software
Dave
electrofix
Moderatorfreezer drefrost heater error
emailed it
Dave
electrofix
Moderatorno probs
thought i had your email but cant find it
let me have it again
Daveelectrofix
Moderatormay not be residual fluff as it may be a valve breakdown
but if it is fluff someone would need to strip it to clean it
had lots of blocked condensorsDave
-
AuthorPosts
