Forum Replies Created
-
AuthorPosts
-
electrofix
Moderatorthats odd because the switch Beko say is the correct one has 3 connections
Dave
July 6, 2023 at 8:53 pm in reply to: Hoover Washer/Dryer H3D4965DCE/1-80 Control PCB holder part Number #487485electrofix
Moderatorlooks like part has a number but not listed
got an idea will try to think on in the morn. got a few scrap panels lying about
Dave
July 6, 2023 at 7:54 pm in reply to: John Lewis Built in dishwasher JLBIDW1319 LIGHTS FLASHING #487466electrofix
Moderatorall 4 codes are to do with pressure switch
Dave
electrofix
Moderator[USER=”125″]don[/USER]
if your online have you any idea ?
Dave
electrofix
Moderatorconnecting the wires together wont help as it looks for shorted or open ntc’s
hoover only sell complete harness but you may find similar connectors somewhere else. these connectors are called insulation displacement connectors as the insulation is broken as the wire is pushed into a metal fork. you can use a small screwdriver to try to ease the wire back in
Dave
July 6, 2023 at 7:24 pm in reply to: Hoover Washer/Dryer H3D4965DCE/1-80 Control PCB holder part Number #487483electrofix
Moderatorok cant see that one
have you got the serial no that is also the commecial code to identify it
Dave
electrofix
Moderatornever used one myself but i would try 3d hot air and set a temp
since its fan lower temp by 10 degrees and expect it to cook quicker
Dave
electrofix
Moderatorwell looking quickly looks like a drain problem
Dave
electrofix
Moderatorwell the rubber is over £100 on siemans site and the lock is in the £75
this unit is made by Smeg for Siemans
so the lock should be
https://shop.ukwhitegoods.co.uk/8144…hine-door-lock
door rubber
https://shop.ukwhitegoods.co.uk/7541…ryer-door-seal
cant be 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} but fairly certain these are correct. you could ask shop to confirm
Dave
electrofix
ModeratorRocketMan wrote:Aaaahhhh Why!!!!!!
I thought a simple Cooker Hood repair. 3 a fuse blown and bulb base stuck in bulb holder. Wait…where the plug?
Had to remove the CH after using my boroscope I found the plug and socket BEHIND the CH. Why? Nearly an hour for a 10 minute job. What an absolute PITAkitchen fitters are wonderful people mmmmm
Dave
electrofix
Moderatorcant hurt to change the door interlock as well
What is the Enr and Fd number ?
Dave
electrofix
Moderatoryes you can test with a multi meter
Dave
electrofix
Moderatorelectrofix
Moderatorassumed the brew unit is not loading and unloading but the motor should not turn. if it was turning either the brew unit should move or the gears have gone
so is the motor moving or not ?
Dave
electrofix
Moderatorok it could well be the door sw thats the problem
it has double contacts so its poss the lamp one is ok but the other has failed
Dave
-
AuthorPosts
