Forum Replies Created
-
Posts
-
F13 I think is the dryer thermistor, did you change this one
on some washer dryers failure of the dryer thermistor stops the pump working properly
Dave
it will run a lot more in warmer weather
and the side must be where the condensor is to let out the heat
Dave
all i can think is try turning machine on its side and see if the drum move up enough to get it
if that wont then you can try releasing the shocks to get it higher but beware of soap dispenser damage so you may have to loosen that as well
Dave
the way this works is this
you do a few jobs and then they start advertising in your area and give you jobs you would have got anyway. the only difference is your making £23 less on every job
Dave
even says the oven should be secured to the work surface. mad they have not considered granite surfaces
think would miss it out as with air flow it wont get that hot anyway
Dave
well you can get a power supply but its about £106
and you cant be certain its the fault although it sounds possible
Dave
well I get part no 642655 at £130 so dont know where you got your part no from. typical Bosch silly prices
try
https://www.ebay.co.uk/itm/372523064831
have used this seller for a few things
this will be a gen panasonic part and the microwave you have uses panasonic works
Dave
quite often caused by contamination and not cleaning the waveguide cover
you can get a used mag for about £25 amd a new one for £46 off ebay
chances are it will be ok once you have changed it but you want know till you do
Dave
its difficult to say although the mag does sound suspect
one thing to beware of it 5000V DC on the mag. This can be there even if the unit is switched off so you need to discharge the wires before touching anything
Dave
another resourse to find things like this is Elementman.co.uk
if you put model in there you get
https://elementman.co.uk/products/new-world-082651882-genuine-grill-oven-element
you can then put the part no in connect to double check
Dave
sometimes drums and frames have more than one place to put the springs
are you sure there are in the original positions
Dave
try
462300001https://shop.ukwhitegoods.co.uk/4623…r-oven-element
the upper element shows 2 different no;s
462300003
462300004
Dave
