Forum Replies Created
-
Posts
-
in Vickie’s case the oullet of the dishwasher goes to a stand pipe and is not connected direct to the sink waste. since this pipe has a water trap ( u bend) that holds water to stop smells from entering a building it can form air locks in the outlet hose if this hose is pushed so far into the pipe that it contacts the water. the outlet hose should be no more than 8 to 10 inches into the pipe
Dave
forget what i said, I have deleted it. somehow i had washing machine in my head
ok you said its warm sometimes, is it plumbed into hot water which could give the impression its heating
Daveyes
part no3872079029
qualtex have the best price for me at £11.50 aswo show at £14.80 all plus vat and carr
wow discounts on Ebay which is connect, show it as £15.12 delivered
sad when its cheaper to get from Ebay than a trade account
Daveyes transit screws was my first thought
did you remove 3 or 4 long bolts from the rear and fit the plastic bungs to fill in the holes they came out of ?
Dave
its unlikely you will get a wiring diagram
Its s fan oven
if fan is running and the temp indicator light is on then its most likely the elementDave
yes the water pressure is used to close the valve but not had any leak through low pressure
what you need to do is take the top off the machine and disconnect the water inlet hoses from the soap dispenser one at a time and see if you have water comong in slowly and to determine which valve is faulty
Dave
if water is getting in the machine it can only be one of 2 things. cold water from the mains or dirty water from the sink
if its cold water from the mains and power is off it has to be a valve fault cant be anything else
Daveto be honest its not that hard
you have to find a normally open one about the right size.
I keep one type in stock and its one from rs components and i pickede it purely on whether it fitted in the space
Dave
sometimes machines continue to fill as its washing
you need to check if the water stops flowing in well before it failts out
Dave
it may be filling but does it know that ?
there is a sensor on the inlet that measures the water if this goes faulty it does not know its filling and gives the fault
when in the programme does this fault happen ?
Dave
