Forum Replies Created
-
Posts
-
the fill side has the reed sw. that measures the number of pulses to determine water load. it cannot measure how much is in there
Dave
this is the closest manual i have found on the later systems
https://www.manualslib.com/manual/95…2u.html#manualinteresting bit on the height of the outlet hose
well if its not too far down the pipe as it could air lock and your sure there is no blockages then it could be the pump
Bosch dishwashers measure the pump current to determine if its empty. if the pump is worn it can draw more current
they call it virtual sensors
you could remove the pump and look for tightness or play
Dave
strange it worked on timed ok
you would have thought this fault would affect both timed and autoDave
paintwork on modern cheaper machines is not what it used to be. If the paintwork get wet too often it will rust
you need to put down some paper and push it under the front of the machine to try to find where the water is coming from
depending on how its plumbed in the water can also come from the plumbing and not the machine
Dave
got email notification the manual cant be delivered to your email
will try again if you need it or have you changed your email ?
Dave
chuffy wrote:Done quite a few belt replacements on WMA’s without too much trouble.
But on this Bush there’s a lot less room to get your hands in.bigger drum capacity probably
Dave
dont thing i like the idea of turning the machine over
the old hotpoint WMA series was similar
there were engineers out there who used to use zip ties to put the belt onmy way of doing it was hook belt on the motor. there was just enough room to get your hand down and hold the belt towards the inner part of the pulley then with the other hand put your arm inside the drum and use the drum as a lever to roll the belt on. you have to be careful your fingers are not through the pulley and be aware of what will happen if the belt slips off while trying to get it on. Also never use somebody else to turn the drum so your in total control
Dave
this is the WMA video using zip tie method
well I tried here
https://parts.indesit.co.uk/?infinit…E&gclsrc=aw.ds
I got C00581045 using commercial codewhich is different again
see what you think
just ran all 3 numbers and they all exist on the site as seperate parts
Dave
