[electrofix]

the manual lists

https://repairtechuk.co.uk/

as repair agents , try ringing them if they still do the repairs and see if they can supply spares

Dave

[electrofix]

depends which Bosch but you will normally have to take the complete front off the machine

Dave

[electrofix]

salt in a washing machine ??

you have the wrong model

Dave

[electrofix]

makes sense

wonder which production lines goes next
they dont want 2 production and design teams and they have 2 of everything at the moment

Dave

[electrofix]

yes that looks fine

the front part gets cold which is why its corroded. the back half is where the heat goes so thats why it looks good

if the compressor is not doing its job properly then it wont get as cold and takes more time to dry

you need to check if the compressor is running ok and the front plate is getting cold

Dave

[electrofix]

https://www.miele.co.uk/c/service-10.htm

click on original spare parts

then click on full spares catalogue

if often cheaper to buy direct from miele

Dave

[electrofix]

whats the model ?

Dave

[electrofix]

had one of them

blocked solid

had to take the drum out to clean it

Dave

[electrofix]

had a Samsung doing something similar

all looked clean but i found caked lint inside the vanes of the evaporator.stopping air flow
used stiff wire to pull it out in small lumps

Dave

[electrofix]

SWERV wrote:Do you use ASWO? They have a couple of alternatives that are much cheaper.

Merv

one of Aswo is made by irca so should be fine

also you can get it for £23 from elementman but Aswo is well worth having at less than £10

Dave

[electrofix]

ok try this

in the manual it tell you how to set various perimeters

try setting one and then reset it

am hoping demo mode is set a similar way and doing this may reset it

Dave

[electrofix]

ok you have to be more specific

what warning lights flash ?

changes programmes and lights run through ? explain

Dave

[electrofix]

that diagram makes it look like the pipe is going under the floor

main thing is dont go up, down , up down so it cant form air locks

done many where the bulk of pipe along floor then it rises to the sink

dont think you will have a problem

Dave

[electrofix]

i use a 25w lamp across the terminals
thats enough to prove the board is ok

problem is now the draw element is a stupid price

Dave

[electrofix]

e06 is a drain fault according to the manual

check filter first just in case

if its draining ok then it could be a blocked pressure chamber
this system along with the pressure switch detects water height

find the pressure switch and remove the tube and blow down it to see if its clear
warning do not blow in the switch itself

Dave

[Author]

Posts