Forum Replies Created
-
Posts
-
am sure I have seen that door before and if i remember you cant buy a handle just a complete door
you will have to contact ElectriQ
https://www.electriq.co.uk/content/accessories
Dave
if your talking about parts 7831 and 32 they are the pipes from the rear.
the picture is looking from the front so those parts are outside the case
Daveits a drum fault , probably the drum spider
you may get the part but it will be over £100 in spares to repair and part may well be obsoleteand its a shame but its time to replace it
Dave
did you check heater to earth with the wires disconnected as 100k to earth is way too low
would expect over 1 meg ohm at the very least and some machines get upset at that level and cause all sorts of problems so over 5 M ohm would be a lot better
Dave
ah so the title is a bit misleading
what your saying is the machine keeps washing and washing and does not proceed
cant remember but i think your machine may be hot and cold fill so you heat at 30 degrees may be the hot fill
first thing i would do is check if the heater has blown and you can do this with a multi meter if you have got one and can use it
Daveyou need to find out where its coming from
could be a gasket or on rare occasions a pin hole in the stainless steel tank
dave
ok
if you set a programme, the machine fills and starts to wash . Does the drum turn at excessive speed at this point ?Dave
