Forum Replies Created
-
Posts
-
no put it together and see how it goes
if the coins were blocking the drain water banging on the drum makes quite a noise
Dave
yours is a washer dryer so things are different
its not unusual to go into spin on dry as its a energy saving feature to get as much water out by spinning
dont know hyow the door glass controls the system but if there is a sensor on the glass it must have a wire which may break by opening and closing the doorDave
short answer if you tilt any refrigertion and turn it straight on you run the risk of scrapping it as the oil can be compressed and if it does get through the compressor it wont get through capilliary tube
did look in owners book and it says nothing apart from if you do tilt it do it on the RHS
Daveyou may get warm air blown around the case but the important thing is
is the air wet or dry
dry air is fine but if moisure is in it you have a seal problem
Dave
there is steam escaping into the casing
you just have to find out where
do my trick, fill it full of wet washing and with the lid off run the machine. then get a mirror or a pair of glasses and move it round to see if it fogs up
davematrixresonator wrote:Aswo certainly my preferred supplier nowadays.
Anyone remember WashVac? used them almost exclusively back in the day.Wash vac were good
Julie from there works for qualtex as Qualtex took on some of their staff when Wolseley took them overstill got a few of their old catalogues lying around
Dave
as far as i can see the condenser is moulded into the drum assembly making it impossible to remove and clear
is a bad design but as with all designs it’s down to cost savings and customers wanting ever cheaper machines
Dave
the delivery lowers in stages up to free at £250
there is also a slower option and thats only £5
but add to that fact that any item you back order have no more p&p and the happily send parcels from more than one depot to complete the order it all is +ve
I add p&p to part prices these days and give the customer the option of getting it quicker by paying the full P&P
free p&p comes at a cost, as a supplier you either raise prices or lower prices and charge carriage
Dave
make sure the wiring loom is well clipped to the drum as it was common to rub through the wiring on the concrete weight if it came loose
Dave
Assume Model should be WM5100W
does not make much sense does it as it uses the same components either way so if one works the other should
Dave
am still getting to grips on what they sell
they have a lot of electronic components and computer parts like usb disk drives etcalso they dont charge extra p&p on bacdk order
Dave
open one its well woth it
they are really good on vestel parts you can use the long serial no to get the exact part
they are better at Bosch prices and have better stock of some things
add to that they have a freephone number and you can actually talk to them
Dave
