[electrofix]

unless 2 spokes break its unlikely to fail
been to a few of them where the customer had not noticed the problem

Dave

[electrofix]

b4u2 wrote:

[USER=”18369″]tubafan[/USER]
what do you mean?

some fridges cool the rear wall and some frost free units take cold air out of the freezer to cool the fridge and control the flow with a motorised flap

Dave

[electrofix]

looks about right
there are only 2 of them from memory and its not diameter its depth one of them is not as deep as the drum rear is at different angle

may have a few around if you get stuck

have a good look at the spokes on yours either as the spoke joins the hub or as it joins the rim

Also have a very careful look at the bearing tube in the plastic drum. had a few of these come loose in the plastic and thats a total scrap job.

Dave

[electrofix]

tubafan wrote:Dave, is this a cold rear wall type fridge rather than a blown air type? If so I assume it has a valve so it can regulate the fridge separately from the freezer?

dont know but parts breakdown should be on Miele site so have a look

Dave

[electrofix]

had a few of them break over the years
should be lots of them about if you need one

Dave

[electrofix]

does the button just turn red or is it flashing

if its flashing does it flash a sequence ie 2 flashes then a break then 2 flashes etc

Dave

[electrofix]

check the spokes of the pulley
if a spoke breaks you will get a click noise

Dave

[electrofix]

well that does sound normal
its only if it does not clear each cycle then there would be a problem

Dave

[electrofix]

b4u2 wrote:They explained to us that it freezes up then defrosts then freezers then defrost and that’s how it works.

thats correct
all depends on your description of excessive ice and frost

does it dissappear and come back again or does it jusr get bigger ?

Dave

[electrofix]

interesting contradiction here

Miele say its normal and yet they have gone to the expense of changeing some very expensive parts

Also did you realise miele dont manufacture these units as they are made for them by Liebherr

Dave

[electrofix]

https://media3.bosch-home.com/Documents/9001424355_A.pdf

have picked one at random as you dont give full enr number

look at page 44 and make sure instructions have been followed

Dave

[electrofix]

dont know why you need it , have not found any diagrams but the is a pic of sw with harness on espares

https://www.espares.co.uk/product/es1540636/oven-function-selector-switch-11ch49-with-wir

Dave

[electrofix]

have emailed you the fault code info

Dave

[electrofix]

have scanned doc into 5 pics and emailed them to you

Dave

[electrofix]

mikehha wrote:dave a question first can the fans be replaced because I can`t find a part number for the fan only the module.And second we are talking about the fans in the main unit fvla057472

probably the fans on the boards

like computers the fan will be monitored so things dont overheat. will try to scan the doc i have

you could check the fans to see if they seem tight or contaminated

Dave

[Author]

Posts