Forum Replies Created
-
Posts
-
there is a double stat but its on the output and not on the heater box. its on the duct after the fan
Dave
the more complex these get the more interacting problems you get
Neff can afford to change parts on a whim we cant
if a clean does not sort it you either tell the customer they pay for the parts even if it does not cure it or walk away and let neff deal with it
even though the control panel is more likely the fault it could also be corrupted power supply from the power Board and as K says a host of other things
walk away
Dave
problem as always is it can be either but more likley the control panel
try giving the panel a really good clean in case its contamination
Dave
someones got the hump for some reason. probably someone retired with nothing else to think about but it has to be close to you as someone 5 or 6 houses away would not be bothered
dont think there is much they can do unless they can prove exessive noise of some kind. even then you might be a lawn fanatic and mow it every 2 days amd that would be noisy. There is lots of people working from home these days and if they stop you they would have to stop them.
the only fly in the ointment is the deeds of your house may say you can’t run a business from the houseyou have to see what they come back with
Dave
thats going to be a hard one
it could be either board
there must be a link cable you could check for damage
will it function without display working ?
Dave
front board is £255
rear board £170
could be a new cooker
do get a similar thing on hoover units with a faulty programme selector but it does not fail to start once i get it to stay on
have emailed you the fault codes and test info
see if it will go into service mode
is it just 1st programme clockwise or if you select any programme quickly will it come on till you move the knob ?
Dave
am sure somewhere on here someone else had a bosch or neff doing the same thing but cant remember outcome
as normal check for odd earth fault , we all know the sort of problems they can cause
after that is has to be board related . have you checked the power board for bulging caps ?
Dave
you can see the panel (3) and the small springs (5) that lock it into position
springs are at the bottom to push panel up and lock into place
Dave
most miele plastic panels move down about 1mm and pop out the top
its a bit fiddely but with small screw drivers and care they pop out
Dave
