Forum Replies Created
-
Posts
-
nope.. that board directly replaces tthe c00143056, and fits a mulitude off machines, its the same as needing an eprom, effectively
scam of the decade
cant advise you im afraid, forum rules and all that
theres a pcb at the base of the machine, thats a good place to start, although since theres nothing, and that wire must be a neutral since its blue – a good place to start would be where the cable comes in and work back
best i can do im afraid
Re: Hotpoint TDL52S: How do you fit a new belt?
Penguin45 wrote:You won’t like it……… I’m a pro and I don’t like it!
Lid off, side panels off, fan cover in the bottom off, remove front fan. Pull drum back, get three friends to help you fight the damn thing round the drum, replace the left hand cover after puttting the drum back on its supports. Haul the belt over the motor shaft, twirl the drum whilst pushing the belt along the motor shaft to get the position approximately right. Refit fan and fan cover. Then it gets difficult. 😯 Somehow, you need to stretch the belt around the jockey pulley. You need something you can pull on vigourously which has a hook on the end and unlimited patience……..
If you live in Leeds, please don’t call me.
Power off first, please.
Penguin45.
front fan?
its a tdl
i undo the 3 bottom screws at the front, and the screws roun the duct, pull it forward, slip belt on, pull over motor shaft and reassemble
i think ur getting it mixed up with a ctd chris
there is no front fan on a vented dryerill have to do it in the morning.. the file isnt on my laptop nemore.. but ill get it for you
sorry for the delay
give samsung a ring
they can identify the date with the serial number
dont spend any money on it, you wont ever stop
good luck
no, it isnt, on my tech diagrams that im supplied, it shows it as one
so it will need rewirin.. that will please them eh
yes, its the cooling fan
normally
althouight there were a couple of conversions to rectify noise on that model
the cooling fan is on the right hand side ( from front)top off, side panel off ( 1 scre on top, 4 down back) slide it backwards slightly and lift it off
the fan is under the grey plastic shield, in front of the beltavailable as a part in the online shop if thats the case
you can u sually see theyre out of shape
oh, and make sure the plugs out
when the hell will hotpoint use their heads?
i mean why cant light 1 be f 01
like f05 being 1 and 4
would make it so much bloody easier, wouldnt it?
1 & 3 is an f10 fault
failing to recognise pressure switch
could be hose off pressure switch, no water supply, faulty pressure switch or, the usual, faulty control board
hope this helps
plug out if your gona look
