Forum Replies Created
-
Posts
-
Re: Electrolux TR1178S – fridge not cooling – freezer OK
just pull it out
then push the new probe in till you cant push it ne further
job done
Re: Hotpoint WD420 flashing power light
:S you’ve just opened a right can of worms there
betya life its blown the board
and thats where the problem starts
theres different boards.. you’ll need
1 > the serial number
2 > the software variation (a sticker on the cover, number starts 271… or summink)
3 > is it cold or hot+cold fill
4 > on certain models, the heater box was changed, but it might not be that new, so that needs to be checkedthen , with all this info, u can look on partfinder for the right board/eprom
i love merloni !!! whatever happened to timers and speed control modules? they were much less bother and lasted longer
Re: Condenser dryer creda t622cw
yup, its probably the relay
however.. just try one thing 1st?check the plug/socket.. ive had rafts of these doing that and its the live connection burnt in the socket outlet..
it might not be that, but your gonna be well hacked off if you change the relay and its still the same
hope this helps
Re: Samsung RS20CCMS freezer frost
its the thermal fuse ull ned to be honest
i change the sensor and the evap cover to be sure
im sure some1 can come up with part numbers?
Re: Hoover HNWL3126 washer/dryer not working
not working at all?
unusual.. id be thinking power supply? maybe a burnt wire on the supresor?
make sure its unplugged if ur gonna check it out
Re: Hotpoint WF440 Etc. surface mounted switches
nope, seen quite a few
its usually because the clear platic bracket on the back of the bezel isnt clipped in properly, and sits funny on the switch
merloni.. dont u just love em?
Re: Zanussi E60 Fault
thought that was e90?
e60 is insfficient heating during wash
check the wash heater/thermistor
hope this helps
Re: Hoover Condensing Tumble Drier Problems – TCE660
zanussi are one of the best dryers out there, quiet, well built, surdy and most of all reliable
whirlpools arent bad, but tend to be a bit rumbly
steer well clear of hotpoint/creda/indesit… ull know wot bother is if u waste money on one of them
hope this helps
Re: blomberg 1501aaa wants to bounce across the kitchen
is the door seal kinked?
a more common problemwas the front weight slipping round and hitting the door hinge… ive seen plenty of these babies bounce around rooms , ive never changed one suspension leg, although im sure it happens
Re: Felt bearing for Zanussi
it pulls tight around the front air duct, and holds itself in place, if its come off, it needs a new one.. and it aint a nice job either
hope this helps
Re: Servis Quartz A
u tried pressing the half load buton?
on a lot of those the dryer wont work if u havent got the half load button deperessed
hope this helps
Re: hvr ab130
assuming the paddles are out…
lie machine on side, remove sump, u can fit 1 screw into the paddle
if the paddles still in its attatched by 2 screws, remove 1 by goin in thru sump, then break the other off, by woteva means possible( short shafted hammer works well)
then refit with 1 screw, otherwise is drum out
hope this helps
