Forum Replies Created
-
Posts
-
Re: comet…again!!
and the depth of feeling from the now redundant comet staff is aparant on facebook.. all this will leave a bitter taste in many mouths for a long time…. and all this one week before christmas
theres just one word i use for opcapita, and i cant use it here, this site has people with morals , but i think you all know what the word is
Re: Candy GOC 580C-80 Tumble Dryer – no heat fault
its more likeley the front ntc on the duct
lid off
bezel off
screws top of panel, botom of panel, round door
front panel pops off, its at the botton of the ductthats the usual suspect tbh
Re: comet…again!!!
Re: Hoover Dynamic 8+ error code 1
i think youll find error 1 is a faulty door lock
e8 is a motor fault
Re: gas cooker at risk in my parents house.
spot on im afraid, there has to b an opening aperture (window or door to outside) it cant vent into another room, its dangerous….
Re: Hotpoint Aquarius WF541 Temperature Control
just a quick one
has no one considered the knob might be broken?
i mean, if the thermistor was faulty either way, there would be a fault code, amd if the relay was stuck on, same thing… but then , this is hotpoint isnt it
Re: Hoover washing machine HNF7167
one of the most common faults i see
the plug needs cutting off, they burn for laughs, and yes u need a pcb, the pump triac will have blown its top
Re: Hoover OPH616 water temperature
…………..which is a waste of money
faulty thermistor…. e5 fault
faulty heater … no heatthe selector dial requires cleaning
Re: comet…again!!!
captaincaveman1 wrote:Feedback from my customers has always been negative towards Comet from the sale’s staff being mainly just kid’s with limited knowledge other then gaining exsperience in how too build a bigmac from previous employent to the service side and having to wait weeeks for parts for the comet engineer to make a service call back with them and scratch his head . Getting shut of comets engineers (the jack of all make’s but master of none) was too little too late . Must be terrible for the store staff though on the run up to christmas
oh very goodamazing how a lot of us ‘kids scratching our heads’ were headhunted by manufacturers?
you wont make friends with sweeping statements like that
👿
Re: integrated cda washing machine f08
Yep, with and without a load
Checked all the wiring as well
Looks like a pcb fault then….
Thanks for thatRe: hoover hnf6167 not spinning
megger the heater then.. but id make sure the spin speed selector is set to full spin first
Re: Error E40 on Zanussi ZWF14581W
my experience is that you will need to recrimp the terminals with good quality insulated connecters
doesnt last long if the wiring has burnt
