Forum Replies Created
-
Posts
-
the heater will cause it to fail if it has gone faulty
very fickle electronics, be careful of how you look at it , if it doesnt like the way you look, itll fail, theyre that unreliable
cant you use a meter, itll take you less than 10 ,minutes to check it for continuity, although if its blown a fuse, theres a good chance its faulty
well, you could have put this in the dishwasher section?
tip machine on its head, 4 screws hold bottom panel on, 2 clips holding heater in place
you will need to buy two new jubilee clips
how do you know its the heater if you dont have a clue where it is?
plug out of course
good luck
no, you take the lid off put your arm down and break the lock
or you could try banging the door wher the handle is, see if you can unjam it
plug out of course
Penguin45 wrote:
helo_75 wrote:
cut that stupid filter off, and disable th flushing valveonly then will it work correctly
For a while………
:p45:
yup, untill the element fails, or the fan motor, or the thermal fuse, or the pcb, or the bearings, or the doors seal, etc, etc, etc
is there ANYTHING ON THAT MACHINE THATS RELIABLE?
well, no itll not shift
youll need a new door seal.. and its just the start of your problems
its mould and bacteria breeding in your machine
there are products that will help you clean your machine out, but the seal will need rplacing
model number?
and its good you guys have someone to help you!
emw are the way forward i agree
for me.. i have 3 boards in my car, a hardware key, a laptop, and a eprom writer.. thats all i need
