Forum Replies Created
-
Posts
-
so now its turned into a battle
face it mate, u aint got a scooby doo
thats more than aparant
its certainly, already cost you more than the repair would have
i actually think its funny
it was feb 2006 when they modified the drum, so im sure at 15-16 months it will have the new type fitted
ok, just to clarify
the pump runs continuously., its supposed to
the float switch turns the light on, the heater off
if you have the light and the heater on, the switch is faulty
simply, if the board has a j10 connection, it needs a wiring change, if not, then its a straight swap
its easy to have a look, just tip it back
the pump runs continually, even when the light is on, it just turns the heater off
the microswitch is faulty
well, that wins the award for the most ridiculous question of the day
what do you want to hear ? that actually theve spent milllions developing a machine to be WORSE than it was?
i suggest you might word your question more appropriately?
f05 is the pressure switch stuck in the full position
f10 is afaulty pressure switch
the machine not emptying correctly is your problem
is the waste pipe in a stand pipe? or is it on a spiggot under the sink ( if it is, u need to just check its exit is clear)
does the pump grind, or is it unnessecarily noisy when it empties?
washer dryer pumps are notorious for going faulty , they do run an excessive amount of time
have you tried putting the hose into a bucket, switchin the machine to spin, and seeing how fast the water comes out?
its got to be an obsstruction, or a faulty pump…
althought if it was faulty, it would give you an f11 fault ( theoretically)
should be alright fitting hinges, as long as you dont take any panles off, or disconnect the gas
bit of a grey area though
