Forum Replies Created
-
Posts
-
Re: Margherita 2000 al128d
Not good news, Indesit made machine, F07 is a faulty heater relay on the main pcb.
Unless you are very good with a soldering iron and also very lucky you will need a new pcb which will need programming, more than the machine is worth TBH. 🙁
Re: Hotpoint WDPG9640 Aquarius + restarting rinse cycle
No trick, just perseverance.
A thin, flat bladed screwdriver is the best thing to use, you need to gently prise the rubber grommet out as best you can. Sometimes completely removing the temp sensor will allow you to get a screwdriver into the rubber to help to get it moving.
Re: Hotpoint WMUD 10637 P (UK) Leaking from dispenser joint
A long time problem on these Indesit machines. Replacing the whole of the dispenser assembly is one solution, it has been modified for this fault several times. Sadly it is not now available as a complete assembly.
Apart from that two things you can try, make sure the water pressure is not to high and adjust the two front feet, screw them out to give the machine a slight backwards tilt.
Re: Hotpoint WDPG9640 Aquarius + restarting rinse cycle
The dryer ntc is a more common cause of weird faults on these TBH.
Re: Hotpoint FDF780. A-1 error code.
Remove the base and take the wiring off the float switch and try again, if it then works you have a problem with the switch or the float mechanism.
If it faults without the switch connected then it suggests you may have got water onto the electronics.
Re: Hotpoint BWD129 error codes please
Manual doesn’t give dryer ntc values but they are the same/similar to the wash ntc.
20kohms@20C
Can be weak wiring connections or blocked condenser or even the pcb. 🙁Re: Hotpoint FDF780. A-1 error code.
You did reconnect the wiring plug to the correct terminals on the float switch?
Re: Hotpoint BHWM129 Flashes and does not open
Error code is F06, a door lock related fault. These Indesit machines use very weak wiring connections and it is very common for them to burn out at the door interlock.
A new interlock is not expensive but you may also have to repair the wiring connections to the door lock.
Re: Hoover showing E15?
Soooo,
Got another one on the phone with E15, is there a quick fix or is it new pcb time?
Re: Hotpoint Aquarius WDXD8640P 8Kg / 6Kg Washer Dryer
Not good news, supposed to be a faulty motor triac ( a part on the main module). If you are very lucky it could just be a loose wiring connection to the 3 phase motor.
Re: Hotpoint BWD129 error codes please
I suppose you mean something like . THIS.
Been there a while now. 😉
