Forum Replies Created
-
Posts
-
Re: Whirlpool drum lifters?
Bump,
I’ve tried to look through all the options in the ‘STORE’ but can’t find that exact model. ❓
Re: Indesit IWDE12 flashing lights and will do nothing
If you mean the bottom light in the right hand vertical column (door lock0 light is on steady then it is trying to tell you that it is very poorly indeed.
Fault code F01.
Main PCB, Triac on board damaged or components.Feedback fault.It could just be broken wiring at the motor plug if you are very lucky.
Re: hoover dryer part number required
Motor is a 40006643, capacitor doesn’t appear in the parts list though?
Re: Hotpoint TVM570p Overheating
Not encountered this personally but have had a couple of customers reporting this fault on newish dryers that have been seen by company engineers recently so there may be a known problem.????
Re: Idesit DIF04b1
Sounds like it may have a corrupted pcb, difficult to suggest what to do without error codes apart from testing all components particularly the heater with a suitable megger or multimeter for insulation faults and visibly inspecting the wiring harness, especially inside the door.
Re: Hotpoint Ultima FDUD43133x Fault code f06
No, but online direct from the Indesit Company will be as good anywhere,
Or HERE
Re: Hotpoint tdc32 won’t stop turning
No, but how do you stop it then, by opening the door ?
Can only really be a faulty timer TBH.
Re: ISE AW23 Knock or Bang
Unplug and take the top off, have a look at the concrete weights on the front of the drum, they sometimes come adrift.
Re: hotpoint aquarius wdl520
Sounds like a main motor fault but if it really did go bang then there is a strong possibility that it will have taken out the electronics, if that is the case then the machine is BER.
Re: Hotpoint Ultima FDUD43133x Fault code f06
Change the water turbine/fill chamber assembly. C00256546. 😉
Re: Idesit DIF04b1
All lights flashing is not a known error code, you could try running the auto test cycle to see if you get an error code.
Starting the Auto Test Cycle
1. Open the door and switch the machine on. (On/Off button)
2. Switch the dishwasher off. (On/Off button)
3. Press and Hold the “P” (programme) Button for 3 seconds. The machine
will beep.
4. Switch the dishwasher on. (On/Off button)
The On/Off Led will flash slowly and LED 2 is on.
5. Close the door, after 4 seconds the machine will beep and the Auto Test
cycle will start after 6 seconds
