Forum Replies Created
-
Posts
-
Re: Creda 37373 Dryer
Nope correct part n’o only differance is the start capacitor should be a 5uf with that one, the old motor used a 7uf capacitor.
Re: Creda iwd12 – bearings failure
Metal drum comes with bearing spider on it, you might need a differant pulley also you will need a sub kit which includes blanking pieces and a new door seal
Re: Whirlpool top loader
thanks for that dave cust has 2 of these she haas been getting somebody else now i have inherited them.
Re: FDW70 Hotpoint dishwasher
Had one recentlty when the wash pump was just pulsing all the time when i looked underneath there was a small harness from the module to a plug going to the motor had burnt conections, trouble is for this little 20cm idc harness they wanted £65 plus vat to buy.
Re: Hotpoint AQXGF149PIUK F01 Fault
You can get a new harness from the motor to the module plug one in and see if it cures the fault if it doesnt your looking at a module, i usualy have a harness to try 1st.
Re: Hotpoint AQXGF149PIUK F01 Fault
The 3 phase motors dont give much problems, it will probl,y be the module but i would plug in another motor harness 1st just to confirm cheersJJ
Re: Panasonic
About time JTM are the biggest waste of space i have ever had the displeasure of dealing with.
Re: cookworks mm55526 selector
40513 on connect this is a differant switch from the original so you need a wiring diagram to fit. JJ
Re: adp8352
Cheers guys the thing is i’m trying to build up an order on Qualtex at the moment and they dont have it in stock, and its a lot cheaper than Connect or masterpart think i’ll just order it from them and wait on it, jj
Re: Hotpoint wmf740 dispenser
Welcome to the mad house that is indesit, must cost a fortune wharehousing all these different parts for the same model n/o but its a different comercial code so there may be 1,2,3,4 etc variants of the part you need.
