Forum Replies Created
-
Posts
-
Re: WF840 Pump start delay?
Almost g/teed a blockage somewhere be it in the sump drain hose or drain, never had to fit a module for that fault. jj
Re: indesit wie157s power surge
If your machine is under 5 years old it is covered by a 5 year parts g/tee, as the E signifies it is an eveloution module with a 5 year parts g/tee, maybe worth getting indesit to have a look.
Re: hotpoint wf560p white wash programme problem!
I take by reduced load you mean mini load, if so it is a heating fault.
Re: wm63 hotpoint
Is it an old GEC motor? if so check the yellow tacho wires are not chaffing on motor casing, these can cause overheating or spin on wash i always tie them to the brush wire with a cable tie as a matter of course.
Re: Indesit Bearings
If you give the edge of the torx pulley bolt a couple of good whacks with a cold chisel, you will find the it will come of no bother at all i’ve never broken a Torx bit since a started doing this.
Re: Indesit WIL103 Auto – fab con not going
I usual unclip top of dispenser from bottom then using a bit off capilary pipe give it a good poke about then flush it out, you need both valves activated to divert water into fab compartment. make sure water press is high enough or it wont dispense also. jj
Re: new partfinder
Its been a nightmare as an engineer emit and stock only recognised the old n/o but the delivery note and parts were stamped with the new n/o, if you couldnt remember the old part n/o we had trawl throught partfinder to dig it out. Thankfully part finder has been updated now and we can cross check parts on it now..
Re: Hotpoint WD860 W/Dry – faded display
Yes display module faulty, also check that door seal isn,t perished around the heatbox excessive steam and moisture escaping can also cause this.
Re: Taurus TLV-1260E
Thanks Kwat it’s a learning curve for me at the minute, just like starting out all over again. chhers jj
Re: FF73P fridge warm
Duff evaporator fan you can get it to run on test but, but wont run for any length when required to cool, had a couple ctatching me out you think its all hunky dorey hear it starting up, then off you go only to be called back a couple of days later.
Re: Indesit bearing removal
A new back plate cannot be fitted to an existing drum, reason being the drum shrinks slightly after a period of time, i,ve heard of one or two engineers claiming they have fitted a new one but i,ve never managed it if the bearings are totally shot its the works i,m afraid.
Re: Hotpoint D41uk no pump
The wash motor is in series with the drain pump, you may have a duff wash motor, causing it not to pump.
