Forum Replies Created
-
Posts
-
Re: Hotpoint wd860p power module connections
I,ve found F01 faults are normaly the motor harness or the module, the motors dont give any bother normaly, have you checked the motor plug for signs of water ingress this will give F01 fault also.
Re: hotpoint ff72p mistral fr/fz
I’ve been caught out a couple of times shoved in thermistors, check in quick start up mode fan runs then wait for fan to start when it cools down, off i went thinking that was it job done, only to be recalled later same fault had to change the fan motor to cure, only 3 times now in the hundreds i’ve repaired but alomst always catches you out.
Re: hotpoint wf220 pressure fault
Sometimes the sw’s that you get the terminal orientation is differant and the plug has to turned 180′ . jj
Re: More Hotpoint rubbish.
Ah! the suggestion scheme those were the days i suggested to fit a heater bollard to repair outer containers after coin damage, only thing was some barsteward tried to knick my idea, good thing my manager seen it and copied it to prove i was 1st, no certificate but £250.
Re: Tips or tricks replacing door seal on Ariston A1535
I have the special pliers they are normal pliers with 2 locating hooks welded 90 degrees on the ends, they hook into the eyelets and you draw them together and a little twist job done, mind you 1st couple of times is a right pain until you suss it out, unfortunatley they are not available now.
Re: Hotpoint VTD00P
I broke my special tool, i use a big flat blade screwdriver now, slip the blade of the screwdriver through the belt then the end under the motor pulley start turning the drum and ease the belt onto the pulley, like jim says 15 mins tops. jj
Re: wma 30 will not finish
Have you removed tthe flap valve in the pump, been recalled a couple of times after a tub change for the very same fault as a matter of course now i laways remove flap valve if it has the plastic sump. jj
Re: Ariston MBA3842c
I’m sure there is a timed module to cure problems of thermistor going out of calibration, i,ve fitted a few for this fault i’m sure it was that model, the only one i had problems after fitting, was in an old large house and the ambient temp was on the low side, and the fridge froze everything due to it running on a timer. I’ll have a look for part n/o to-morrow cheers jj Part n/o is 2503982 though it ihas been
superseded dont know the supersision n/o ‘
