Forum Replies Created
-
Posts
-
Re: bosch washing machine brush motor
Well I’ve fitted a pair of cbn2222 on a wae28364 tonight and they sound better than the originals do
Re: Dedietrich induction hob
Model is vti704v and haven’t worked on a induction hob so any point where to start would be very much appreciated kai
Re: Noisy Hoover WDXP596
The way to check if it’s the motor just remove the belt and run on spin cycle kai
Re: Belling BI60G Gas Oven Dead
As it’s a gas cooker only a gas safe registered engineer can work on it so can only say it’s probably a timer fault.
Re: Hoover DNY10144D3x
The error codes for these machine always start e0 then a number from 1 upwards e08 is a main motor problem and e09 is a main pcb problem
Re: Samsung heat pump dryer DV80F5E5HGW
Only thing to check which is a nightmare to do as it’s a full strip down is to clean the fluff out of the evaporater and fan area.
Re: Hoover vtc671w
3 main faults on these dryers either the heater is faulty , the pcb , or front ntc, like iadom has said if the fault is definitely eo8 this is a heater fault
Re: samsung washer carbon brushes
Normally if I remember correctly I think the orange indesit brushes will fit
Re: Hoover HNV380 excess fluff and air escaping
It sounds like to me either the front panel or door seal are not fitted correctly more than likely the door seal
Re: Zanussi ZKG7125 washer dryer
I know this might sound stupid but have you tried disconnecting the dryer heater they give allsorts of faults
Re: Indesit IWE7145 given up the ghost…
More than likely the main pcb is at fault they are expensive 😕
